front or back speakers?
the back speakers, you must remove the rear seat. it is simply held by two bolts on the bottom edge of the seat. once you get them out, there is two torx bolts you must remove. then you will just pick up on the back rest and it will easily come out.
depends on engine, mounting, body, ecm, and about a million other things, but possibily
follow the link for your wiring codes
What size are the speakers in a 1992 standard cab Chevy S10?
Start with the lack of freon.
where is the freeze plug located on a 1992 Chevy beretta and I need a picture on it also
it is on the side almost at the bottom of the radiator..very hard to get too !!!!
if its burnt out, replace it, if not, check the wireing
4X6 inch in dash and in the b pillars
Yes it does... i have a 96 beretta, and it did not come standard in the model. you have to buy the belt for the blower. go to your local advance auto store and they will easily help you
It has 1 O2 sensor on the exhaust manifold behind the engine
Dont rice it out, make it a rice eater
Sounds like a bad ground somewhere..steve
front struts berings
Could be the throttle position sensor
Giacomo Beretta was born on 1992-03-14.
Duilio Beretta was born on 1992-02-25.
Only the 5-speeds. You can't swap automatics without running into problems, and you can't swap an automatic for a 5-speed without modifying (and it will still throw an engine code afterward). A 1992 Corsica had a 3T40 automatic, and the 1995 Beretta had a 4T60E automatic. Your best bet is to swap in another 4T60E. It came in a lot of GM vehicles. Go to car-part.com and enter "1995 Chevy Beretta automatic transmission" in the search for a list compatible transmissions and prices in your area.
Jacob Beretta was born on March 7, 1992, in Tennessee, USA.
The thermostat is on the right side of the engine. It almost touches the intake manifold. It is in a round casing with a bolt directly in the top of it.
No. The fuel pumps changed in 1993 to a different design, from that point on the pump and sending unit were integrated into one unit. They will not interchange.
Assuming it's the ever-common 3.1 liter V6, it should be on the front of the block between the radiator and the block.
Go to a parts store or bookstore and buy a Haynes Manual.
there is no alternator on the 1992 Lumina its all electric, so there is no need for one.
you most likely need to change them