answersLogoWhite

0


Best Answer

Look down into the engine bay and the starter is behind the manifold on the right side of the engine. 1. Disconnect the red lead on the battery 2. Raise the front of the car and support on jackstands.. DO NOT WORK BENEATH AN UNSUPPORTED VEHICLE 3. Label and disconnect the wires from the terminal and solenoid. 4. Undo the three bolts that hold in the starter. Install is reverse of removal Time.. under 1 hr

User Avatar

Wiki User

โˆ™ 2008-08-14 17:57:20
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you change the starter on a 1988 Chrysler LeBaron?
Write your answer...
Submit
Related questions

Where is a 1988 Chrysler lebaron 4 cylinder starter solenoid?

It is on the starter.


Where is the starter on a 1988 Chrysler LeBaron?

Hey Jermaine==It is at the rear of the engine. Follow the pos batttery cable. GoodluckJoe


Where is the hydraulic reservoir for 1988 Chrysler lebaron convertible top?

Where is the hydraulic reservoir for 1988 Chysler Lebaron convertible top?


Are 1988 Chrysler Lebaron's stick shifts?

Some were


What kind of oil does a 1988 Chrysler LeBaron use?

5w30 or 10w30


What type of freon does a 1988 Chrysler lebaron use?

R-12


Where to find an owners manual for a 1988 Chrysler LeBaron convertible?

You can find owner\'s manuals for 1988 Chrysler LeBarons online at find.com and amazon.com.


What controls the egr valve on a 1988 2.5 Chrysler Lebaron?

The engine computer controlls it.


How do you replace 1988 Chrysler LeBaron brakes?

Front or rear.. disc or drum type..??????????


Does a 1988 Chrysler LeBaron 2.5 Automatic have a timing belt or chain?

It has a timing belt.


Where is the back up light switch on a 1988 Chrysler LeBaron?

It is on the front of the transmission case.


How do you change a starter on a 1988 Toyota Cressida?

Change a starter on a 1988 Toyota Cressida


Where is the heater core on 1988 Chrysler lebaron convertible?

Inside of the car. Remove the glove box.


Where are the spark plugs on a 1988 Chrysler lebaron?

They are screwed into the cylinder head, at the end of the plug wires.


Where is the dipstick for transmission on a 1988 Chrysler Le Baron?

The dipstick is on the lower front of the transmission on a LeBaron.


What is the white smoke out of exhaust on 1988 Chrysler lebaron is it water in the engine?

Most likely it is a failed head gasket.


Why won't my 1988 Chrysler lebaron start?

re:why won't my lebaron start. I left out some details.... It just quit starting one day. I replaced the relay fuse on the advice of a friend ,but it didn't affect it at all. The is no click or any sounds indicating that it is even trying to start. IF there is no click it sounds like starter or bad connection to starter Check wires to starter and battery posts for corrosion first


Where is the fuel filter located on a 1988 Chrysler LeBaron?

The filter is located under the car on the passenger's side just forward of the rear tire.


Where is the solenoid on a 1988 Chrysler Lebaron?

Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.


Where is the fuel filter located on an 1988 Chrysler Lebaron?

passenger side, under car, just behind pass door, in front of gas tank


Where is a diagram for finding the vacuum line for a 1988 Chrysler LeBaron?

It should be somewhere in the engine compartment, if it has been removed then you can try: http://minimopar.knizefamily.net/vacuum.html


How do you change the starter in a 1988 Isuzu Trooper?

to change the starter for Isuzu trooper is easy way to oper the exhaust pipe first.then you can reach easly to starter.


How do you set the clock in a 1988 Chrysler Lebaron?

To set the clock on a 1988 Chrysler Lebaron you start by pressing the "set" button while the radio is on and push the volume knob in. Once you see the hour number flashing on the screen, adjust by using "seek" and press the volume knob in once you set the hour and then it will go to minutes. Adjust the minutes using the same "seek" button and press the volume knob in and the time will be set.


1988 Chrysler lebaron 2.5 stalls but after 10 or 15 minutes it starts?

Stalling can occur for several reasons. The first step in troubleshooting these cars is to check the fault codes.


Where is the fuse box located in a 1988 Chrysler LeBaron?

On my 1986 Chrysler lebaron the fuse box is located in the glove box.Open the glove box and on the right hand side of it is a fuse panelAnswerOn most cars, the fuse box is located under the dash near the kick panel on the driver's side.