0
Starter
Removal & Installation
1. Disconnect the negative battery cable.
2. Raise and safely support the vehicle.
3. Remove the starter terminal cover.
4. Remove the terminal nut and separate the battery starter cable from the starter motor.
5. Disconnect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid.
Ø To disconnect the hard-shell connector from the solenoid (S) terminal, grasp the plastic shell and pull off; do not pull on the wire. Pull straight off to prevent damage to the connector and (S) terminal.
6. Remove the starter motor retaining bolts.
7. Remove the starter motor from the vehicle.
To Install:
8. Place the starter motor in position and install the starter motor retaining bolts. Tighten the bolts to 15-20 ft. lbs. (20-27 Nm).
9. Install the battery starter cable and a terminal nut to the starter motor. Tighten the terminal nuts to 79 inch lbs. (9 Nm).
10. Connect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid.
11. Install the starter solenoid safety cap. If equipped.
12. Lower the vehicle.
13. Connect the negative battery cable.
14. Start the engine several times to check starter motor operation.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What in the location of the main relay on 96 F150 300 6cylinder?
Fusable link? Check at starter solenoid
Does a 1993 ford f150 300 straight 6cylinder have a timing chain or belt?
It has a timing chain.
Were is the PCV valve on a 1992 f150 with the 5.0 in it?
where is the pcv valve on a 1992 f150 with 5.0 liter
How do you change a starter on a 1996 Ford F150?
first- disconnect the battery or you'll be sorry.ZAP! second- disconnect the wires from the starter third- unbolt two bolts and you are done. Tada!
Why wont my f150 turn over?
starter is out, motor is locked up or your starter solenoid is out.
Where is starter on 89 Ford F-150?
Location of starter on 89 ford f150
Where is the started solenoid on a 2005 ford f150?
On the Starter
FWhy does F150 starter burn out?
Starters can fail over time, or a broken tooth on the flywheel could be causing a bind. If the starter is failing over and over and is an aftermarket type, then it may be necessary to change back to a factory starter replacement.
Where is the starter located 1998 F150?
on bottom side of engine
Does a 1992 ford f150 have a torsion bar?
NO
Where is the oxygen sensor on a 1990 ford F150 and how do you change it?
Near the starter on the exhaust header. If it is 1990 it will be fun to break the rusty sensor out of the truck. good luck
Where is the starter relay located on a 2002 f150 pick up?
The starter relay is located on the battery side of the engine compartment on a 2002 F150 pick up truck. It is on the firewall close to the battery.
