Car Starting Problems
Starters and Ignition Systems
GMC Sonoma
Chevy Colorado

How do you change the starter on a 1994 GMC Sonoma 2.2?

626364

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 20:47:14
2015-07-15 20:47:14

I have a 96 2.2 and had to drop the exhaust from the manifold in order to change the starter. and goos luck.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4

How do you flush the raditor on a 1992 GMC Sonoma Pickup.

The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.

The starter of the 1994 GMC Sierra 1500 pickup is located on the dashboard. It is usually attached by a small wire.

No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.

The GMC S-15 became the GMC Sonoma in 1991.

Mounted on top and inside the fuel tank.

You Must take the exhaust off at the manifold.

A person an change the starter on a 2002 GMC Sierra 1500 by disconnecting the battery and removing the retaining bolts on the starter. The original starter is then disconnected from the wiring and a new starter reconnected.

You have to get a stering wheel puller.. Take it off.. Pop it out and put the new one in like you took the old one out..

Where is the timing connector on a 1995 gmc sonoma

To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.

4x6 in dash and 6 1/2 inch in doors

The torque specs for the 1994-1995 GMC Sonoma for the bolts that bolt the transmission to the engine block are 23 ft. pounds or 276 inch-lbs. This is for the S4 NV1500/3500.

i have a 91 sonoma. For advice it was easiest to unbolt the the flywheel/flexplate cover. this allows you to wiggle the starter towards the front of the truck and then lower it down. ( you do not need to remove the cover; just move it out of the way.

where is the iat sensor located on a 2003 gmc sonoma truck

What size is the starter bolt on 6.5 turbo diesel starter?

The starter is definitely under the hood. Try getting under and looking where the engine is bolted to the transmission. It will be right there.

what are the torque specs for a head on a 2.2 liter gmc sonoma

On the sides of the engine block


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.