Take the light assy off and they screw in from the back.
there are plastic fasteners in the trunk, take them off and pull tail lamp out. replace bulb and re-install
NOTE There are THREE (3) black plastic nuts holding on each tail light assembly! It won't come off until you take all 3 out, and you do not have to take the trunk liner off either.
Once you take the 3 plastic nuts off, the tail light assembly will come loose and pull out so you can change the bulbs.
The third nut is in the corner of the trunk up near the top.
To change the high mount stop light bulbs in the middle of the trunk lid remove 4 black plastic liner things, like screws, they pull out, then fold back the trunk lid liner and you'll see the bulb sockets. They twist out 1/4 turn like usual.
A 2001 Intrepid does not have an oil change light.
It is very easy to change the license plate bulb in a 2001 Dodge Intrepid. You will need to remove the tag and then unscrew the light cover. After the cover is off, unscrew the light and replace with a new one.
trunk light is located in the trunk
With the hood up look at the outer end of the Headlight, You will see what looks like a snap together piece. wiggle the corner light and this will help you to see the clip that has to be moved in order for the light to slide out so you can change the bulb...I myself just put new headlights in my 96 dodge intrepid.
Inside the trunk there is a turnable thumb screws where the brake lights are. Twist screws off and the brake light pops out.
Trunk light switch is part of the trunk light socket assembly...
The airbag computer has detected a malfunction and set a code.
there are two tourqu screws one on each side undo thes and slide out light then release the clip on the bulb from the back side and slide out the bulb
i have dodge intrapid 2.7l my 02 sensor light come on p0051
how to turn off engine light on 2002 Chrysler int
Battery disconnect or a scan tool.
Bulb, wire, fuse, etc.
You may need to replace the power control module.
disconnect battery for 30 seconds
It might be a dodge intrepid. The 1967 Dodge Charger had one long tail/brake light .
in the trunk there are 3 plastic wing nuts take them off and the light will come out.
Not via a manual, but the most amount that I've ever used (full tank to "empty light" on) was just under 14 gallons. 2002 Dodge Intrepid SE, 2.7L Engine.
Charging system failure:::,check alt.voltage regulator is inside engine controller
pull the whole light down from the head liner (it is just held on by 2 clips it will not break )then you pull the light itself from the holder change it and reinstall the complete light assy. to the head liner
Pop the trunk, remove the "3 wingnuts" behind or on the carpet. That will in turn loosen the tail lights. Turn the bulb, and voila!
No. It has a unlit reference. The illuminated selector in on the center dash.
There are three plastic nuts accessible from inside the trunk.
After checking the code, and repairing the cause, you clear the code with a scan tool.