you follow the bottom radiator hose to the thermostat housing and disconnect the electrical connector ( the housing is located at the front of the intake manifold) you loosen the hose clamp and remove the hose then take out the housing bolts and remove the housing and the thermostat is right there make sure you put the new one in the same way the old one came out
how to i change a clutch in a 1993 ford ranger
yes if the motors are the same.
Yes , the 2.3 liter 4 cylinder in a 1993 Ford Ranger is a non-interference engine
I have a '93 Ford Explorer and it hold 19 gallons From the Chilton Ford Ranger guide: "1993 Ranger with standard wheelbase: 16.3 1993 Ranger with long wheelbase: 19.6"
It is on the cylinder head near the thermostat housing.
waste of time
Just follow the top radiator hose from the radiator . It connects to a metal pipe which is part of the thermostat housing that is bolted to the front of the engine . The engine thermostat is inside the thermostat housing
The 4 cylinder in a 1993 Ford Ranger is 2.3 liter ( 140 cubic inches )
The thermostat is located inside of the thermostat housing. It is on top of the motor where the top radiator hose connects. you will have to disconnect the hose to remove the thermostat housing.
Follow the upper Radiator house to the thermostat housing, there's 3 bolts holding it on. Take off the housing, remove the old thermostat, put in the new one and replace the housing. Make sure you drain the radiator first.
you just need to hone it out and replace parts with rebuild kit.
I believe that is inside the manual transmission bell housing
yes they will the only thing you might have to do is change the brackets.
On a 1993 Ford Ranger , 4.0 liter V6 engine : Follow the top radiator hose from the radiator , it connects to a metal pipe that is part of the engine cooling thermostat housing that is bolted to the front of the engine . The engine cooling thermostat is inside the housing
no none of the answers were my question
Follow the upper radiator hose to the block, and it clamps onto a [thermostat] housing, remove the hose and that housing the there you go!
The bleed valve is located on the drivers side of the bell housing.
no,output shaft is too long
can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?
It is inside the part where your upper radiator hose is fastened onto the motor.
where is location of thermostat in ford aerostar van, 1993
follow the hose from the radiator top to the radiator fill cap....undo the cap and you will see the thermostat sitting right there...pull up on the metal kind of handle and the thermostat is out!! lane
Drain the water from your radiator. Remove the radiator hose, from the thermostat housing. Remove the thermostat housing retaining bolts. Replace the thermostat housing gasket and reverse the process to install the new thermostat.
In a 1993 Ford Ranger : The 2.3 liter four cylinder engine has a timing BELT and The 3.0 and 4.0 liter V6 engines have a timing CHAIN
Follow the upper radiator hose to the engine. The spigot that the hose attaches to should have 2 bolts holding it to the engine block. The thermostat should be located under that spigot.