The thermostat is located under the housing at the end of the upper hose that goes from the radiator to the engine. Drain the radiator then remove the hose at the thermostat housing. Unbolt the two bolts that hold down the housing and pull out the thermostat (be sure to notice which end of the thermostat points into the engine. Installation is reverse , making sure that thermostat points in the same direction. Usually, the instructions of how it fits are printed on the package of the thermostat. Good luck.
that is the cooling fan relay.
Yes the 1994 Mazda Protege is a OBD 1 port
where is the modulator vavle on my 1994 Mazda protege dx?
The starter, on a 1994 Mazda Protege, is located on the driver's side of the engine. It is just behind and to the right of the oil fill cap.
No, it has motorized seat belts. The 1994 Protege is essentially the same car as the 1990 Protege, which is an economy car that cost about $10,000 new.
i need to change my alternator belt and don't know where the tension wheel is so i can take off the other belt to replace the alternator belt on my 94 Mazda protege 1.6l
The first Mazda Protege, also called the Mazda 323 and the Sixth Generation, was manufactured in 1989, and the car's production lasted for six years until 1994.
try going on ebay!
the alternator is located under the inlet manifold
14.5 gallons AFAIK.
Like any other wheel?
6.5 inches. No screw patters match the protege, you'll have to drill alittle bit.
The only tool that is really needed to remove the distributer cap off of 1994 Mazda Protege is a screwdriver. Using this tool will enable you to loosen the cap, and then you can remove it.
Have your Mazda dealer parts department print out a picture of the relays location for you. They will do this if you ask them.
Behind the engine, under neath the intake manifold.
Email me for the Fuse diagram email@example.com
is under the transmission stick console, heres a web page for mre info. http://www.scribd.com/doc/51604740/Mazda-Protege-Workshop-Manual-1994-1998R-English
There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.
When you remove the caliper, the pads can be pressed out by hand.
This is an NHTSA-listed Safety Recall item. All Mazda USA dealers are to perform this Safety Recall work free of charge for all 1990-1994 Mazda Proteges and 1990-1994 Mazda 323s, but only if indicated by either a malfuntioning driver- or passenger-side passive shoulder belt.
at the bottom of the air filter housing.
How do i change my 1994 mazda 626 alternater
aft side of the engine about the center bottom area.