The top cam gear should have an arrow cut into the inside of the gear this points straight up at 12 o clock and the crank pulley has two groves cut into the inside lip one large and one small the smaller on is 0 degrees and is to the left side of the bigger one, that is to be lined up with the timing tab above it where that too has a notch cut in at 0 degrees again at almost 12 o clock. very simple.
It will cost approximately $500 to change the timing belt in your 2002 escort. The exact cost is dependent upon several factors.
Yes. its on the timing belt and therfore difficult to change.
how do i set the timing on a 1995 ford escort LX??
The timing chain for a 1993 Ford escort is located on the front of the engine. It is under the timing chain cover.
Im replacing the timing belt on a 1995 Ford Escort 1.9L. How do I Set the timing on it?
it should be checked every 3rd oil change 5-10000 km
There is no suck thing as a timing sensor. The timing marks for a escort are not on the cams you must use a straight edge.
"How to set timing on 1991 ford escort lx 1.9?"
It has a timing belt
No , it's a timing BELT
water pump is located under timing belt cover! change it when you change the belt.
Ignition timing is not adjustable. Cam timing is adjustable by the "guess" method unless you are replacing the timing belt and using the timing marks on the belt drive cogs, in which case you need a repair manual that has detailed instructions.
The water pump should be driven by the timing belt, yes. If you change the water pump, you might wanna change the timing belt and tensioner while you're in there.
97 ford escort 2000 timing belt replacement
I was looking at the 1999 Ford Escort scheduled maintenance guide and the Gates website ( they make timing belts etc . ) and both show to inspect the timing belt at 120,000 miles , replace if necessary ( that applies to both the 2.0 liter SOHC and DOHC engines )
Most Timing Belts are changed at 60,000 miles. Calling a Ford Dealership would be more specific though.
The water pump is inside the timing cover and is run by the timing belt. If you are going to replace it, change out the belt at the same time.
About 4 hours considering if you have all the tools .
get a haynes or chilton manual the job is quite involved you have to remove the timing cover and belt and such. when you do the job change the timing belt since you will there anyway.
There are no timing marks. The timing is controlled by the PCM. Power control module. It is not possible to set the timing with a timing gun.
The timing marks are on the timing cover for the crank pulley, and on the cyl head for the cam ...
I think the computer automatically calculates timing. No marks.
This car will use a timing belt.