I am working on this. It is not a good idea. If the belt broke, I was told the valves may have hit the pistons. If you are looking to replace a worn belt, go get it done at an auto shop. The belt needs a special tool, and adjustment. It takes 2 hours to replace the belt, and you need a wheel puller.
It is behind the Timing Cover. Torwards the crank pulley.
Can you take a Ford Ranger 1994 bed and put it on a 1994 Mazda B2300? Truth be told, they are the same truck. My 1995 B2300 has "Made for Mazda by Ford" on a sticker inside the door of the driver's side. Also, the Chilton's manual for the Mazda B series trucks are the same as the one for the Ford Ranger.
Polk Audio db571 or Infinity Reference 6822cf
A vacuum leak is one possibility.
It maybe a leak in the intake manifold gasket.
how to replace power steering pump on 1994 Mazda b2300
use a c clamp to squeeze the piston closed
i have a 1995 madza b2300 truck & i believe that the 94 and 95's are identical. i am trying to remove and replace the water pump. i have all 4 bolts removed but i can't get the water pump off the bracket. thanks
go to www.drivetrain.com and find your particular vehicle
To the best of my knowledge it will only work on a !996 or newer.
Mazda b2300 b 2500
they have a ribbed timing belt
On a 1994 Mazda MX-6 : Both the 2.0 liter four cylinder engine and the 2.5 liter V6 engine have a timing BELT
I would guess you are low on transmission fluid.
How do i change my 1994 mazda 626 alternater
take em off 1by1 and put them back on after each one you take off
no timing belt
The location of the turn signal flasher on a 1994 Mazda B2300 P/U is located on the fuse block under the dash. Most likely, yours is located there also.
If you have to ask such an obtuse question I suggest you just take to a local shop and have it done.
i have a mazda 1994 626 v6 24 valve car and i think the timing belt just broke where are all the timing marks crank shaft and cams?
In a 1994 Mazda 626 : Both the 2.0 litre four cylinder engine and the 2.5 litre V6 engine have a timing BELT
Kind of hard to explain and describe the process. Recommend you purchase Haynes Repair Manual #36071 (1993-2005 Ford Ranger Pickups/ 1994-2005 Mazda Pickups) or check at your local library to see if there is one available. You will find all the steps plus illustrations on how to perform the job.
Replace the cam seal.
Did you try disconnecting the positive battery terminal for a minute then reconnecting it? Soemtimes this will reset the computer and the light will go out.