Car Computers and Sensors
Mercury Sable

How do you change the transmission mounted speed sensor on a 98' mercury sable?

001

Top Answer
User Avatar
Wiki User
Answered
2014-08-23 06:21:30
2014-08-23 06:21:30

The sensor will either screw in or have a bolt holding it. Disconnect the wiring plug then unscrew or remove the bolt to change.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


depends on if it is the input sensor (mounted in the transmission) or the output (on the passenger side transaxle)


There is no Cable it is a speed sensor on the transmission


It's mounted to the top of the transmission at the back. It has a two wire connector and is heal on by one screw.


Its mounted on the transmission.


The speed sensor is mounted at the top of the transmission towards the rear. It has a two wire connector and one mounting screw.


The sensor on the 1994 Chevy Caprice is located on the transmission. it is mounted on the tail shaft of the transmission.


The crank sensor is mounted on the top of the transmission bell housing.


The transmission range sensor is mounted on the drivers side of the transmission. It is bolted around the shifter shaft as it comes out of the transmission.


The crank position sensor is mounted on transmission bell housing in the front.


It is mounted to the rear of the throttle body.


Mass air flow sensor is mounted after the air filter.


The speed sensor is at the top rear of the transmission housing.


on my 1999 ford mercury villager its on top of transmission under the van




The crank sensor is mounted on the top rear of the transmission bell housing.


The crankshaft sensor is mounted to the top rear of the transmission bell housing.


Its the sensor that regulates the overdrive on the car. Its bolted to the transmission. Its $90 bucks. If your car starts jumping RPM's on the freeway, Its bad. Change it.


The speed sensor is mounted on the right side of the transmission case below the starter.


The speed sensor on a 2000 Mercury Village is found on the transmission of the vehicle. The sensor will be placed on top of the unit to read the rotations of the transaxle.


Top rear corner of the transmission.


The vehicle speed sensor is at the top rear corner of the transmission housing.


It is mounted in the air cleaner intake snorkel.


The 2003 Trailblazer speed sensor is mounted on the transmission. It is on the passenger side of the output end.


On V6 and V8 models the crakshaft position sensor is mounted on the passenger side of the transmission bellhousing.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.