where is the ecu located on a 97 ford probe
THERE WAS NO FORD PROBE IN MODEL YEAR 1985
try this link it may help keep in mind ford probe's have Mazda engine's
You have to remove the inside door panel then you can see the holding assembly
Takes about 5 minutes if it is a 2.5L V-6.
would you rather it shift slow????????
There is no clutch fluid reservoir on a 1997 Probe. On this car, it is the same as the brake fluid reservoir.
1989 to 1997 ( according to Answers.com )
Check Related links below
www . motorcraft . com ( no spaces ) shows ( .044 inch ) spark plug gap for the 4 cylinder and V6 engines in a 1997 Ford Probe
5W30 , according to the Owner Guide
According to the ( 1997 ) Ford Probe Owner Guide : ( 15.5 U.S. gallons / 58.5 litres )
The Ford Probe was discontinued in 1997 after 8 years of production. You can only buy them used. The comparable vehicle would be the Ford Fusion which has a MSRP of 21600$.
You trying to steal it?
No , according to the Gates website ( they make timing belts etcetera ) the 2.0 liter four cylinder engine in a 1997 Ford Probe ( IS AN INTERFERENCE ENGINE )
Ford Probe was created in 1989.
Ok well the ford probe discontinued production in 1997. On all Ford Probe models the fuel pump is located in the gas tank. So to service and or replace it you have to drop the gas tank. Not fun
According to the 1997 Ford Probe Owner Guide : With engine oil filter change : The 2.5 liter V6 engine takes ( 4.2 U.S. quarts / 4.0 liters of 5W-30 ) * 5W-30 is the PREFERRED oil
take out the old on and put in the new one
If you go to a junk yard it would be around $20-50. I bought on e for a 1996 probe for $15
No it won't. I had a 95 Ford Probe Se 2.0L and when the transmission went i upgraded to a 93 Probe Gt 2.5L V6 and my insurance didn't change at all. I love the car.
20 minutes if you know what your doing. i just watched my buddy change my driver side shaft in my driveway in just under 20 minutes.
When my 1997 Ford Probe started to do that we toke a look at it and found a few leaks in the Air Intake