I had to work this out at the weekend...and failed to use gloves (regrettably) cost $15 from Kia Remove Mass Air Flow pipe from Valve cover, then detach hose at rear of valve cover, and hose on left hand side. Remove Plastic Spark Plug cover, and remove coils (leave plugs). Remove all Bolts from inside plug cover (x8) and 9 from the outside (the last one is from behind the timing belt cover. The rear ones are tough, as there is little space to work. Then gently remove the valve cover, you may have to divert the spark cables and small hoses behind the Transmission Fluid dip stick. Remove and refit the seal / gasket, and ensure there is a little oil on the top of the block when you replace the valve cover, just tighten bolts to hand tight fit, (you may need to put a piece of newspaper between the screwdriver/wrench handle and your hand to gain sufficient grip. Reverse the process and you should be good to go.
i need a detailed diagram on how to replace a valve cover gasket on an 2002 kia sportage. no one makes a repair guide for this vehical
Remove the valve cover. Peel off the old valve cover gasket. Clean the valve cover gasket surface. Insert the new valve cover gasket.
Remove the valve cover.....scrape off old gasket.....clean gasket surface on valve cover....apply gasket sealent to valve cover gasket surface.....set gasket in sealent.....reinstall valve cover.
hoe tdo you change a valve cover gasket on a daewoo nubira
Remove the valve cover retaining bolts. Remove the valve cover gasket and clean the gasket surface. Put the new valve cover gasket on and return the valve cover to its original position.
how do i remove the valve cover to change the gasket in a toyota camry 1996
how do you change valve cover gasket 2004 hyundai elantra
how to replace valve cover gasket toyota rav4 2001
The valve cover gasket on a Harley 883 motorcycle is changed by unbolting the valve cover and lifting it from the engine. The gasket can then be removed, the surface cleaned, and a new gasket put in place.
You will need to remove the valve cover from your 1995 Mercury Villager. Peel the valve cover gasket off of the valve cover. Clean the valve cover surface. Apply the new valve cover gasket.
With RTV gasket silicone. There is no stock gasket not even from the factory.
you should only change the gasket if you have to take the valve cover off....... you should only change the gasket if you have to take the valve cover off.......