If the windshield washer pump on a '93 Honda Civic is in the same place as a '94 Honda Civic, it is located on the drivers side front fender between the wheelwell and the fender. First, turn your steering wheel as far as possible to the right so that the tire will be out of the way. Next, you have to separate the bumper's side fairing from the vehicle to expose the washer resovoir(sp). Next, disconnect the power to the pump by unplugging the snap-on connector. Next, place your hand on top of the washer pump by the prongs. Pull downwards and the pump will pop out of the resovoir tank.
It's really easy. The wiper motor is most likely attached with machined screws on the passenger side of your car directly in front of the windshield (under the hood). Just detach the plug, unscrew the old motor, screw in the new one, and attach the existing plug. Good as new. Part is probably about $75-$100.
pump is in between innerr and outer fender on drivers side pop clips on inner fender yo access
The windshield washer pump on a 2007 Chevrolet Impala is fastened to the engine firewall by 4 bolts. Remove the 4 bolts and remove the pump. Reverse the process to install the new pump.
I know where the two fuse boxes are, but no where in the owners manual does it give information as to which fuse is the one that controls the windshield washer pump. Does anyone know by number, what fuse # controls the windshield washer pump?
i would have to say to take it to a shop they can fix it for you spend the money its not a part to mess with
It is on the bottom of the washer bottle.
In order to change the washer pump on a 97 Jeep Cherokee Sport you must remove the grill assembly and then the driver's side front quarter panel. Once the quarter panel is removed you can see the washer fluid reervoir and the pumps fit into the reservoir. The majority of the work is in getting the quarter panel off. The front quarter panel is attached with screws and bolts located at the front (under the grill assembly), at the back (the door must be open to reach these), and on the top and bottom (including around the wheel well). I recently replaced mine and then a week later the replacement pump went out, bummer.
The grand Cherokee is a body style, sport is a trim package that is used on all jeep models(wrangler, Cherokee, grand Cherokee, patriot, ...)
I know where the two fuse boxes are, but no where in the owners manual does it give information as to which fuse is the one that controls the windshield washer pump. Does anyone know by number, what fuse # controls the windshield washer pump?
i would have to say to take it to a shop they can fix it for you spend the money its not a part to mess with
It is on the bottom of the washer bottle.
stuck to the washer jug in the finder
open your hood. look at your air filter housing. driverside. it is located on your fender wall across from your air filter.
Follow the hoses from the washer outlet spray heads backward to the washer reservoir.
On a Mitsubishi Montero Sport, the front bottle, or tank, for the windshield washer fluid is right behind the passenger headlight in the engine. It is just inside the passenger front bumper.
Follow the hoses from the washer outlet spray heads backward to the washer reservoir.
Your washer fluid is low, or the indicator is stuck. The washer bottle would have to be removed and checked.
I have a '98, and when the "LOW WASHER" light comes on and it finally runs out of fluid, I can put almost a full gallon into the reservoir.
I have an 01 Montero ( not sport ) and I found the container for rear washer fluid is in the rear door, under a plastic flap. Actually the rear door has a pocket in it, and this flap was in the pocket area. Maybe the same for the sport - I don't know.
In order to change the washer pump on a 97 Jeep Cherokee Sport you must remove the grill assembly and then the driver's side front quarter panel. Once the quarter panel is removed you can see the washer fluid reervoir and the pumps fit into the reservoir. The majority of the work is in getting the quarter panel off. The front quarter panel is attached with screws and bolts located at the front (under the grill assembly), at the back (the door must be open to reach these), and on the top and bottom (including around the wheel well). I recently replaced mine and then a week later the replacement pump went out, bummer.