Should be located in a removable housing at the engine end of theupper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Replace housing Re-fill coolant slowly to prevent an airlock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
How do you change the abs pump on a 2001 gmc jimmy
where it the temp sensor sender located on a 2001 gmc Jimmy
heater control valve located on 2001 gmc jimmy 4.3l
When you service the cooling system.
howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy
2001
6 quarts
spring goes toward engine
A diagram of the heater core of a 2001 GMC Jimmy can be found in the service manual. It outlines the location of all the components and how they are connected.
in the gas tank
The bolt pattern for a 2001 GMC Jimmy is 5 by 4.75 inches. The bolt patter is the same for a full size Blazer and the S10 Blazer.
The gear ratio of a 2001 GMC Jimmy 4x4 is probably 3.73. The ratio is listed on a plate in the glove compartment on most models.