you have to remove the intake manifold then you have to remove the ignition coil and then remove the 8 bolt on each side (have fun removing the bolt) jejejeje then you take the cover off an you finish
The oil in a 1993 Isuzu Rodeo is put into the reservoir that is located on top of the valve cover. There is a cap that has to be rotated to remove it.
remove the 2 screws from the red plastic and gently pry the red cover off.
It is behind the timing belt cover.
It is located under the timing belt cover.
simply logon to /www.myisuzuparts.com/index.php
There is a third screw between the brake light and the bumper.
Its in the headliner above the rear door. The cover on it pops right off.
There is a plastic cover inside the rear door jamb along side the tailight assembly. This cover snaps off and back on but take care not to break it as it does take some effort to remove.
Remove Camshaft fro isuzu trooper 1996
Valve cover gaskets will age over time and become brittle and once that happens ... first time so you don't have to slide it around much and disturb the sealer. ... How to Change the Valve Cover Gaskets on a New Beetle · How to Change ..
If its the bulb you have to unscrew the light cover and pull out the old bulb and put the new one in.Then screw the cover back on.
This is a very good answer below but it does NOT apply to a 1999 Isuzu Rodeo. The Rodeo's transmission is sealed, you cannot check fluid levels at home, you must take the vehicle to an authorized Isuzu mechanic so they can check the tranny fluid for you. Transmission: Keep an eye on your oil level, as it can get low on you real quick, especially on long hi speed highway trips. There are ways to remedy this. If equipped with an AT, your rodeo has a 4L30E GM trans. You should change the ATF. BMac- for the ATF leak thing, check the accumulator piston cover on the pass side of the trans. VERY common on the 4L30E. Leaks? How about the accumulator cover? It's on the right side and it's round. Check this: Accumulator repair: before trying to remove the snap ring you need to push the accumulator cover in then remove the cover don