Buick Regal

How do you change water pump on a 1996 buick regal v6 3.8 engine?

345

Top Answer
User Avatar
Wiki User
Answered
2009-05-28 08:57:13
2009-05-28 08:57:13

Buy a Chiltons manual.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions



Engine compartment, on passenger side. Back box by the water reservoirs.


hi my car is leaking from the water pump so what can i do to stop leak ? and if i need to change the water pump would you guys tell me how can i change it?my car is 1997 Buick LeSabre v6 engine


Possibly located on passenger side of engine below and slightly to the left of the water pump.


Under hood, passenger side, lower engine area, below water pump, mounted on timing cover.


A 50/50 mixture of antifreeze and distilled water.


Low coolant? Thermostat not opening? Water pump not circulating coolant?


Drain the radiator on the 94 Regal. Remove the water pump belt (remove the fan and shroud if necessary.) Unbolt the water pump. Install the new pump, then reverse the instructions to finish the installation.


It isn't easy. If you want, get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM for about $9 and it will show you how.


Usually 50 / 50 , up to 60 % antifreeze in colder climates


Regular green antifreeze of any manufacturer will be fine in a 50-50 mix with water




Low coolant? Heater core airbound, restricted, or plugged? Bad thermostat? Water pump not circulating coolant?


If this is a rubber hose it's your water pump bypass hose. it is called a bypass tube and to replace it you have to pull the belt tensioner. this is awnsered near the end of buick regal questions.


First take the cables off then the hold down then lift the battery out. Clean the battery box with a mixture of soda and water then spray it with WD40 then install the new battery and clean the cables before you reinstall them.



The fuel pump on the 84 3.8 v6 regal is mounted on the front driver side of the motor, behind the water pump, between the power steering and pollution pump. Removing pumps and brackets may be required.


Yeah, that's it!!!!! Have the engine running while you replace the water pump.... This kind of question is a good example of why children are taught NOT to eat paste.


The location of a water pump on a 1995 Buick Skylark 4 cylinder is next to the engine. It is found directly under the alternator.


On the 3.1L & 3.8L engines, the CMP sensor is located on the timing cover, behind the water pump, near the camshaft sprocket.


Yes, there is a weep hole near the bearing on the water pump. When the seal goes bad, or when the bearing has to much play it in, it will start leaking fluid there.


on the back of the engine down bottom. gm Jim



Drain the radiator, and dispose of the fluids as it is toxic to animals. Remove the water pump belt. Take off the fan and fan shroud if they are in the way. Unbolt the pump, remove it, then install the new pump. Replace the belt, fan and shroud, then refill the radiator with new coolant.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.