Chevy S-10
Check Engine Light
Dodge Durango
Toyota Land Cruiser

How do you check the codes in a 1995 Chevy S-10 2.2?

262728

Top Answer
User Avatar
Wiki User
2008-06-29 03:47:51
2008-06-29 03:47:51

92 is PRE-OBDII, so you'll have to get a GM specific code reader. They aren't too expensive, usually about $35 - $45 depending on where you get them. They include instructions and diagnostic codes. The code readers generally plug in below and to the left of a GM steering column, just above where your left shin would be if you were driving.

== ==

Actually, the 95 was one of the first with an OBDII, so a ODBII code reader will work, but most auto part stores will not check it, even though it has an ODBII (you can lie and tell them it is a 96 and they'll do it). The code reader attaches below the steering column.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

check for engine codes- it could be that there is a bad o2 sensor or something.

User Avatar

You have it checked for codes and diagnose the cause of the code.

User Avatar

You can use main bearings on a 1995 Chevy S10. The bearings can be purchased at most auto parts stores.

User Avatar

see if you are getting spark in your wires. or check for cracks and damage.

User Avatar

No. Air bags were introduced on the 1995 S10 Chevrolets.

User Avatar

1995 chevy s10 what years are the front end body parts interchanable

User Avatar

Check inside the glove box, on a 1995 the are behind a panel at the back, clearly marked.

User Avatar

Normally your dipstick has a hot and cold mark on it. If not check it hot, always check it with the engine running on an even surface.

User Avatar

I have 4.3L v6 in my 95 S10, it holds 20 gals.

User Avatar

I have a 1992 Chevy S10 pick up and the fuel pump on my truck is inside the gas tank.

User Avatar

No. The 95 4.3 is TBI. The 97 is CFI.

User Avatar

It is important to know the firing order of an engine. The firing order of a 1995 Chevy S10 4 cylinder engine is 1-3-4-2.

User Avatar

Need to know what engine you have.

User Avatar

If it is CFI, the fuel pressure regulator could be leaking fuel. If the check engine light is on, have the codes read.

User Avatar

Not likely but it may be possible to install it.

User Avatar

check for a vacuum leak.

User Avatar

The oil capacity of a 1995 Chevy S10 V6 4.3L is 4.5 quarts when the oil filter is also changed. Oil levels should be checked with the dip stick to verify levels.

User Avatar

Chevy did not use a crankshaft sensor in 1995.If it won't fire then I would check the ignition module in the distributor and more then likey replace it. Also check the ignition coil and WIRE / coil wire.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.