remove the trunk lining or bend it back easy where the brake light is to access it and change it out.
3157 - See sources and related links for picture, specifications and 1999 Lincoln Continental full light bulb list.
Where is abs fuse at
You have to remove the trunk liner from the rear of the car,and then remove the three bolts that hold the taillight into place.
You probably have a blown brake light fuse for whatever reason. The shift lock operates on the same circuit as the brake lights so check the fuse first.
its a speed sensor. about 95$ plus labor
It means check your transmission, why not start with the oil.
the Lincoln continental shares the same dash with the mark series. The continental had a 2.3 turbo as an available option.
Check on the upper end of brake pedal (under dash)
Check the operation and alignment of the stop light switch - usually located at the upper end of the brake pedal under dash area
Check for a blown brake light fuse ( in the fuse panel ) or the brake light switch at the brake pedal could be the problem. The brake light switch releases the shifter lock as well as operating the brake lights.
The brake lights and the tail lights are separate circuits. Check the brake light fuse, then check the brake light bulbs, then check the brake light switch.
Those are completely separate circuits. First check the brake light bulbs to be sure they are not burned out. If they check okay, check the brake light fuse. If the fuse checks okay, check the brake light switch.
1998 Lincoln Continental brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
You may have blown a fuse. Check your fuses. Then you can check your light connections.
Im not sure what you mean by RELAY brake light switch. There is 1 brake light switch on the brake pedal. Check it with an OHM meter,wires disconnected brake off should be "open" (no connection) press the pedal and should have no resistance (0 OHMS)
Some are accessable from the trunk. If not, take the light assy off.
There is a problem with the SRS...have a dealer check it.
first check brake light fuse second check light bulbs,they should be double element third check the brake light switch located on the brake pedal
Check the brake light switch on the brake pedal
Check the brake light bulbs, Check the brake light fuse, Check the brake light switch, In that order.
CHECK the brAKE LIGHT SWICTH ABOVE THE PEDAL ANOUT 10 inches ,by chech see rear brake lights work. CHECK the brAKE LIGHT SWICTH ABOVE THE PEDAL ANOUT 10 inches ,by chech see rear brake lights work.
Check the brake light fuse first. Then check for a bad brake light switch at the brake pedal.
Break light fuse
if the check brake light is on, the accumulator is bad. this part will run 700.00for a rebuilt one. the other option is to replace the brake system with a non anti-lock brake system