0
There are two sets of leads under the dash, steering column side, one set black, one set green. connect black leads ignition on, but do not start the engine! this will allow the engine management light to blink out the code (long blink = 10 short blink =1)
connect green leads, drive car for 1 min at over 10 mph, stop and hold car revs at 2000rpm
you will then get four long blinks from engine light, disconnect leads and problem is cleared from memory!
mine turned out to be a sticky waste gate!
oh and if engine light is on very often, car will not rev past 4200 rpm as it goes into defense mode if it senses a problem!!
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Reading trouble codes 1998 Subaru Forester?
Try your local auto part store. The ones near me will read the codes for free. --Ken
Where do you right the codes?
Are you asking how to clear engine trouble codes? You'll need a code scanner with a reset/erase feature.
How long after you reset the check engine light do the codes clear in your cars computer?
pretty much instantly. As soon as the codes are cleared the check engine light goes off and vice versa, unless there still is trouble. In this case the codes won't clear until the trouble is repaired.
How do you clear trouble codes on a 2001 dodge stratus?
At home you can disconnect your neg. battery terminal for a few minutes then reconnect. Also, to find the codes (what kind of problem you have) go to Auto Zone and they will run a check for free (they say they won't clear the codes for you though).
How do you clear the codes on 2000 Dodge Stratus?
After performing checking procedures on any OBD-II components, clear the PCM of all trouble codes by disconnecting the negative cable from the remote battery terminal for at least ten seconds.
How can you test or erase the trouble codes manually on a 2001 Nissan Quest?
Borrow, rent or buy a good quality OBD2 code scanner. The good ones let you clear the codes. Any codes that WON'T clear are usually caused by a failed component that needs to be replaced.
How do you clear out the check engine light on a 1993 GMC Suburban?
Disconnect the Battery. Negative prefered. Wait a couple minutes and reconnect. This will clear codes on 1994 and older. If the light comes back on, check the trouble codes and a repair may be needed.
How do you reset check engine light to a 1997 Buick skylark?
check obd2 with scanner for trouble codes find problem, fix or replace sensor or part, clear codes with scan tool
2001 Kia ODBII trouble codes?
Troublcodes.net Trouble Codes OBD & OBD2 Trouble Codes and Technical info & Tool Store. By BAT Auto Technical
Does auto zone clear codes?
No.....its against the law to clear codes.
What is indicated by the flash codes?
Diagnostic Trouble Codes.
Why wont codes clear when trying to clear them?
The codes are telling you there is a problem. If the problem is not fixed the codes will come back.
