to clear a "check engine" light on a Volvo 940:
First you have to plug the test cable into socket 2 for fuel injection or 6 for ignition codes. The codes are read as groups of red led flashes.
1)turn the ignition switch to "run" position, press the diagnostic button for 5-8 seconds, then release. the LED would come on.
2)press the diagnostic button for over 5 seconds until the LED goes off.
3)press the diagnostic button for 1-3 seconds, if the LED shows "1 1 1" , that means the DTC have been cleared.
if you have any question, please contact my at firstname.lastname@example.org jerry
Trying to clear the check engine light in a Kia Sorento yourself is not recommended. The check engine light could indicate a serious problem and the car should be inspected by someone qualified.
You can clear a service engine soon light in an Infinite G35 by checking to see if the "check engine" light is flashing. If it is isn't, go ahead and clear the service engine light.
Did you try unhooking the battery
It is the one next to the service light.....second to the right.
I clear the check engine light with a Scangauge II. But most ODB-II devices can read and clear the code.
A check engine light displaying on a Volvo V40 means maintenance is needed on the car. Check the car's instruction manuals to see each mileage checkup recommended by the manufacturer.Ê
disconnect the battery for 1min or so the light will go off
You do battery reset, if that doesn't help then go to diagnostics and Engine ECU and check what code does it give.
the oxygen sensor(sensors)
There isn't a single fuse for the check engine light. See related questions for explanations of why the light comes on and how to clear it.
No, a person cannot just clean a check engine light to pass inspection. The issue causing the check engine light must be dealt with and fixed.
A scan tool is required to clear the check engine light. If the failure is not repaired, the light will return.
If the check engine light stays on for the Nissan Pulsar n16, you would need to check the engine in order to clear codes. You can take the car for service and the problem will be diagnosed and restored to normalcy.
how do you reset engine light on 1991 volvo 240
A person can reset the check engine light by using an OBD scanner to clear the codes. This is after the problem is fixed.
Have vehicle scanned to determine the problem
With an OBD2 code reader
The check engine light on a VW Golf is reset by connecting an OBDII code reader. It can then clear any warnings and turn off the light.
After repairing the cause of the code, you clear the code with a scan tool.
Assuming you want to clear/reset the check engine light, if you have successfully made repairs to correct what was the cause of the check engine light to go on the light will clear itself after a few drive cycles.
That is the check engine light.That is the check engine light.
You clear the light with an OBD2 scan tool after the problem that set the light and fault code has been repaired.
You can disconnect the battery for a few minutes and that will clear the light. If there is a problem with the engine the check engine light will come back on. If it comes back on you will have to have the computer code read and fix the problem.
if your take it to a autozone tell them you have a check engine light and they will tell you whats wrong if anything and reset it take it to autozone and tell them your check engine light is on and they should reset it