Presumably you are referring to an a.c. current?
If so, then the average value of an a.c. current is zero so, clearly, you cannot determine its maximum value.
However, average current is more-usually applied over half a cycle, in which case, for a sinusoidal current, this value is 0.637 Imax. So the maximum current will be the average value, divided by 0.637.
Uttar Pradesh
Portugal's average temperature in October is 64 degrees Fahrenheit [18 degrees Celsius]. The average minimum temperature is 57 degrees Fahrenheit [14 degrees Celsius]. The average maximum temperature is 72 degrees Fahrenheit [22 degrees Celsius].Average precipitation is 2.4 inches [62 millimeters].October has a daily average of 7.5 hours of sunlight.
You cannot "convert" 9 amps in watts. Amps are a unit of electric current, and watts are a unit of electric power. Power is given by P = IV where P is power, I is current and V is voltage. To determine the power (or wattage) you must know both the current and voltage.
Given an undirected graph G=(V,E) and an integer k, find induced subgraph H=(U,F) of G of maximum size (maximum in terms of the number of vertices) such that all vertices of H have degree at least k
the formula for electric current is VI ,where v is voltage then I is the current. the unit used for current is ampere and volts for voltage. multiply the total I to the Voltage The formular of electric current is given by I=V/R ,I=P/V
You are, presumably, referring to alternating current, in which case the 'maximum' current is the peak or amplitude of the waveform. The 'average' value of current is zero, because the average value of the first half of each cycle is negated by the average value over the second half of each cycle. This is why a.c. currents and voltages are always expressed in 'root-mean-square' (r.m.s.) values which is the value of an a.c. current that does the same amount of work as a given value of d.c. current. The r.m.s. value for a sinusoidal current (and voltage, as voltage and current are proportional) is 0.707 times the peak or maximum value.
A: is not current or voltage but rather the product that is of concern
in parallel
The resulting maximum current is limited by the resistance of the inductor. As the current increases from zero to that maximum value, its expanding magnetic field induces a voltage into the inductor which opposes the rise in that current. So, instead of reaching its maximum value instantaneously, it takes some time -determined by the equation:time to maximum current = 5 L / R (seconds)where L = inductance of inductor in henrys, and R = resistance of inductor in ohms.
No direct answer can be given as you do not state which currency you wish to convert from. However see the link below for current currency values.
rated current is the current at any given conditions......but full load current is the maximum current that the system design can hav.....it w'll b larger than that f the rated current. rated current is the current at any given conditions......but full load current is the maximum current that the system design can hav.....it w'll b larger than that f the rated current.
There is no way to legitimately raise the average in a given set of numbers. What you can do is collect more data. If the new data is higher than the current average, it will increase the average that you currently have.
15;hours
i was given an assignment , I'm not current i was given an assignment , I'm not current i was given an assignment , I'm not current
Absolute humidity refers to the amount of water vapor that exists in a given volume of air at a given time. Relative humidity is absolute humidity relative to the maximum humidity for the current temperature.
An argmax is a mathematical term for the argument of the maximum - the set of points of a given argument for which a given function attains its maximum value.
53 in the maximum.