Use a Chevrolet Socket Part number 870245 (a hammer). Seriously though there is usually a control module under the driver's side dash.2I would recomend taking it to the dealer because if it says LOC on the radio they have a code to get rid of it. 3Check your owners manual, sometimes it has a procedure in it for deactivating that system. In a Ford I just had to leave the key in it for 10 minutes in the correct ignition position, and then it started right up.
The easiest way to deactivate the 1999 Chevrolet Cavalier antitheft system is to remove the fuse. The location of the antitheft system fuse will be listed on the inside cover of the fuse box.
You can deactivate the passive antitheft system on your Ford focus by removing the antitheft system fuse. The location of the fuse can be found on the inside cover of the fuse box.
how do you deactivate the anti-theft system on a 2005 Chevy impala
break the window and drive away real fast
My car won't. Start no power to the fuel pump because of the antitheft
Not as a factory option.
disactivate the antitheft
You can bypass the factory security system in your 2004 Chevrolet Impala by removing the factory security system fuse. You can find the factory security system fuse in the fuse box.
EVAP system flow during non-purge.
what is the cost to repair password for antitheft system chevy malibu 2001?
They are located before and after the catalytic converters in the exhaust system.
.You can reset the antitheft system, on your 2003 Chevrolet Cavalier, by removing the fuse. Keep the fuse out for 10 seconds. Replace the fuse to its original slot
In most cases the theft deterrent system in your 2007 Chevrolet Impala will reset itself in 10 minutes. You can also remove the fuse for 10 seconds and replace it to reset the system.
See Content Theft-Deterrent(If Equipped) on page 2-12 of your "Owner's Manual", under Section 2: Features and Controls...
The easiest way to disarm your antitheft system on your 1988 Nissan Maxima is to remove the fuse. The antitheft system fuse location can be found on the inside cover of the fuse box.
This forum is Not intended to answer questions that are questionable as to there use either legal or illegal and or immoral. If the dealership wishes to give you the information that is their decision.
You need to clarify your question as to what you are referring such as engine or evaporative system.
Turn the key off and on for three times and that should prime the system.
You can disarm your 1998 Ford Ranger antitheft system by removing the antitheft system fuse. The fuse is located in the fuse box.
Deactivate the battery
You can reset your antitheft system by removing the antitheft fuse. Keep the fuse out for 10 seconds. Replace the fuse to its original slot.
1) Just start your car with the coded key 2) Pull the battery cable but do not leave it off too long only a few short seconds. (if you leave it off too long the pcm will forget the saved key code then you will need your pcm flashed in order to work with your key again) 3)Bypass the antithief by removing the antitheft wirers. The antitheft system only cuts power to the starter. run your own wiring to the ignition switch to bypass the antitheft.
You need to take it to a repair and have then scan the system for codes and diagnosis it. It could be as simple as dirt on a sensor.
You need to have the system pressure tested for leaks. The intake manifolds give alot of trouble.
Trouble code P0410 means:Secondary air injection system malfunction