1) Just start your car with the coded key
2) Pull the battery cable but do not leave it off too long only a few short seconds. (if you leave it off too long the pcm will forget the saved key code then you will need your pcm flashed in order to work with your key again)
3)Bypass the antithief by removing the antitheft wirers. The antitheft system only cuts power to the starter. run your own wiring to the ignition switch to bypass the antitheft.
You remove the hood latch and diconnect the plug. The car will think that the hood is always open and it will not activate.
How do you disable the Anti-Theft light in the 1993 ford explorer
My Mazda is a 94. There is a black switch near the hinge on the driver's door about 6" from the floor board in front of the fuse box. The down position turns it off.
Car wont start,anti theft system is activated,
No, the 1993 Mazda Protege DX does not have an airbag. The vehicle does have a passive restraints system and is extremely reliable.
this when help me open the hood on the right side of the radiator has a module or relay it sayz csi pull it out and what a couple of seconds then put it back in then try check your alarm it should workby chris from Hawaii alohaAnswerI have my 1993 Mazda in the shop right now because of the anti-theft system going off all the time. I have to disconnect the battery to stop it. They told me you cannot disconnect the system for some reason. I have looked in my manual and cannot find out how to disconnect it either. If someone knows the answer, I would love to hear it. Thanks Cheryl
The Anti-Theft code that is associated with the "Theft Deterrent System" is a 5-digit code located on the underside of the ashtray.
YOu need to blead the system .. then it should require no adjusting
No.
I would also like to know the answer to this question. Anyone?
Follow + battery cable should connect to solenoid
For my Mazda I use 10w-30