The 1994 Chevrolet Astro Van ABS fuse is located in the fuse box. The ABS fuse will be in the second column, third from the top.
There is no ABS relay on a Chevy 2002 Astro Van. If the ABS light is on it is indicating a problem with the vehicle that should be checked out.
pull out the fuse
How do you disable the ABS Control on a 1999 Venture?
How do you disable the abs on 2008 yaris
brake and abs light on , on 1994 Chevy Cavalier Z24
on my 1994 astro van something in the ABS told the computer that it didnt have any brakes and wouldn't let the trans shift any higher than 2nd gear.
The PCM and ABS computers are under the hood mounted low and to the right. There is no separate BCM on an Astro.
at the abs pump. you brakes will now react normally, but your abs light will stay on
Why would you want to disable the ABS?
You could remove the abs fuse located under the hood in the power distribution center, but keep in mind the abs light will remain on and the abs system will not function if needed.
Yes it does, I have one!
You can pull the fuse but in doing so you also take out the ABS in the process.
Pull the fuse for it, labelled "ABS."
lokk in your fuse ox and disconect re abs fuse or find the abs unit and disconnect the wire assembly. Just a word of advise and that is if you disable an ABS or Air Bag system and you are involved in an accident, the insurance company may NOT pay for yhe damages. They are there to prevent injury. CALL YOUR INSURANCE COMPANY BEFORE YOU DO DISCONNECT ANYTHING.
I have a 1994 Chevy Cavalier and the ABS light is flashing
The ABS pump relay is intergrated into the EHCU (elecro-hydraulic control Unit) and it is not serviceable. If the ABS pump relay is defective, the entire control unit must be replaced.
if u want to disable it , there is a fuse box in the engine compartment , pull the fuse your abs will be disable, why take it off anyway
pull mthe fuse under the hood a 60 amp fuse it worked for me.
There'll be one at each drive tire.
the abs pump needs to be replaced it has a relay that is built into it that defaults to on and will allow the abs pump to continue to run with the key off
There is a fuse for almost every electrical part on the car. To disable the ABS system on this vehicle, the person needs to pull the ABS fuse or relay. On the diagram it will be labeled as ABS.
You may have a bad wheel speed sensor on one of the front wheels.
Where is the abs module located on a 2004 Chevy Tahoe
it is a 1995 Chevy blazer and it will not go into park. have to use the emergency brake when stopped, and neutral to start it