Seat Belts and Safety Systems
Chrysler Sebring
Jeep Liberty Sport

How do you disable the seat belt warning on a Chrysler sebring?

444546

Top Answer
User Avatar
Wiki User
Answered
2008-10-07 19:47:07
2008-10-07 19:47:07

The Enhanced Warning System (BeltAlert) can be enabled

or disabled by your authorized dealer or by

following these steps:

NOTE: The following steps must occur within the first

60 seconds of the ignition switch being turned to the ON

or START position. DaimlerChrysler does not recommend

deactivating the Enhanced Warning System

(BeltAlert).

1. Turn the ignition switch to the OFF position and

buckle the driver's seat belt.

2. Start the engine and wait for the Seat Belt Warning

Light to turn off.

3. Within 60 seconds of starting the vehicle, unbuckle

and then re-buckle the driver's seat belt at least three

times within 10 seconds, ending with the seat belt

buckled.

NOTE: Watch for the Seat BeltWarning Light to turn on

while unbuckling and off while re-buckling the seat belt.

It may be necessary to retract the seat belt.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Look in you owners manual for enhanced warning system. The instructions are there. Other than that, wear your seat belt, it is the law.

The 1998 Chrysler Sebring has a timing belt.

A Sebring is a Chrysler not a Pontiac. It can have a seperate belt depending on the year and engine.A Sebring is a Chrysler not a Pontiac. It can have a seperate belt depending on the year and engine.

If a Chrysler Sebring has a supercharger it is aftermarket and not factory.If a Chrysler Sebring has a supercharger it is aftermarket and not factory.

The Chrysler Sebring drive belt can be found on the front of the engine. It is also referred to as a serpentine belt. The timing belt can be found behind the front engine cover.

There are 3 seatbelts in the back seat of a Chrysler Sebring Convertible. The middle seat belt is just a lap belt though.

plug the seatbelt in.. the warning stops then ;-)

On engines with a timing belt, it is inside the passenger side of the engine.

The 2.7L has a chain. All other engines have a timing belt.

The 2.7L has a chain, all other engines have a belt.

Replace the timing belt every 100,000 miles.

Change the timing belt every 100,000 miles.

The cost to replace a timing belt on a Chrysler Sebring can vary depending on the area you are in and if you do the job yourself or take it to a shop. You will have the cost of the belt and labor costs for the job if you take it to a shop.

If the timing belt in the 1998 Chrysler Sebring causes damage to the valves and the head when it breaks, they will have to be replaced. It is recommended that the water pump also be replaced when replacing the timing belt.

its just below and to the left of the alternator

A 2.7L has a chain, all other engines have a belt.

2.7L is a chain. All others are a belt.

It is inside the passenger side of the engine.

The alternator is driven by the serpentine belt. Follow the belt around the engine and you will find the alternator.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.