Disconnect the driveshaft at the rear end and pull it out of the trans.
I need to replace release bearing in a 1995 Chevy s10 truck and need to know how to disconnect the hydraulic clutch line for the transmission.
replace your pressure plate (diaphragm type), and the clutch. replace your pressure plate (diaphragm type), and the clutch.
Verify that the clutch is working. If there are noises, there is a problem. Disconnect the negative charge. Lift the vehicle up and support it. Support the engine with a hoist. Disconnect clutch linkage. Remove the clutch and replace it.
theres no adjustment. need to replace the clutch.or if clutch is new you need to bleed the slave cilinder by the transmission
pull out the transmission
On
ask the mechanic from the Nissan company
the clutch is burnt up. buy a clutch kit check your slave cylinder for leaks, its bolted on the side of transmission,if its leaking ,replace,if not ,then it could be u need a new clutch.
Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced. Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced.
A transmission that does not use a clutch and pressure plate to disconnect from the engine.
I need an answer to this too.
get a mecanic to do the job