Jeep
GMC Yukon
VW Fox
Ford Ranger XLT

How do you disconnect the horn on a 1996 jeep Ranger when it keeps going off when you turn the wheel?

979899

Top Answer
User Avatar
Wiki User
Answered
2007-03-28 20:33:22
2007-03-28 20:33:22

I am not familiar with the Jeep Ranger model. I think you mean Jeep Wrangler which started its' poduction run in 1987-1996 reconfigured in 1997- present. I'm not if you have a driver's side air-bag on yours. If not you need to remove the horn cap and see if any part of the horn assembly is making metal to metal contact as you turn the wheel. If you cannot see any contact being made you will have to remove the steering wheel. For this task you will need a steering wheel puller tool. It gets a bit more complicated as you dig deeper into the steering wheel innards. Good luck. If what you are asking is how to make the horn stop honking till you get it fixed .. There is a plug on the back of the horn under the hood.. Just unplug it till you get the steering column problem fixed..

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


You can't disconnect the 4-wheel drive. The Mountaineer is a ALL WHEEL DRIVE S.U.V.

A 1998 Ford Ranger is rear wheel drive ( or 4X4 capable )

A2. Disconnect the front driveshaft. A1. For a manual 4 wheel drive, turn the hub lock counter-clockwise. The knob is located in the center of the wheel. Make sure shift stick is not in the 4X4 position.

how do i replace front wheel bearinbs on 2000 ford ranger 4wd

If you had your first kiss on the Ferris wheel with your girlfriend and the moment keeps playing over and over again, you're not going crazy. If you need to be distracted, try a new hobby.

If it is connected, disconnect it Switch it off, and then on again Hold down the select button (the centre botton) while also pressing the top of the wheel (the Menu part). The iPod should reset itself and start normally.

They should. As far as I know, they have the same number of lugs.

flat tow 4 wheel drive ranger

I pull one with my 04 ford ranger but it's only a small 19 foot fifth wheel

No. The Contour is a front-wheel drive car, and the Ranger is rear wheel drive.

You can remove the steering will, on your Ford Ranger pickup truck, by removing the steering wheel pin. Remove the wiring harness and the steering wheel will come off.

No. Rear wheel drive or 4wd

Rear wheel drive or 4 wheel drive capable

rear wheel drive ( and maybe 4 wheel drive capable )

what is the lug/bolt pattern for a 2000 ford ranger?

2002 ranger wont go in 4wheel

Well I would say Yes, I have 1997 ranger and I had to pull the dash out twice. Removing the steering wheel made it a lot easer. I disconnected mine from under the dash and took out four nuts holding it to the bottom of the dash frame. Make sure you disconnect the Battery and then the airbag wire under the dash.

On the 1998 Ford Ranger , rear ABS brakes were standard on the XL and XLT 2 wheel drive and 4 wheel ABS was an option on the 2 wheel drive models. The more expensive 4x4 XLT version came with 4 wheel ABS according to my Consumer Guide book - Helpfull My Ranger does have 4 wheel ABS.

rear wheel drive ( and maybe 4 wheel drive capable )

No. The axle shafts are directly connected to the wheel hub which is what the wheel bolts to. There is no disconnect anywhere in the front axle. The only disconnect is in the transfer case.

well if your wanting to know how it turns so sharp basically if two wheels are going it will go strait if the right wheel stops and the left wheel keeps going then it will turn right if the left wheel stops it will turn left get it and no i do not like to capitalize or put punctuation marks

no , it's rear wheel drive or 4X4 capable

rear wheel drive ( or four wheel drive capable )

No , rear wheel drive or 4x4 capable


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.