How do you drain coolant 2005 pilot?
HOW TO DRAIN and refill COOLANT from a system which doesn't have radiator cap Would the coolant reach the radiator is we refill the coolant through the coolant header tank?
The basic method of draining the coolant is the same in all cars. Basically there should be a drain plug at the lower part of the radiator. Look in the car handbook to locate this. Open this and keep a bucket or container as it will drain fluid. Once drained, close the drain plug and top it with coolant. Check the ratio of the coolant mixture on the bottle
Where on the engine block of a 1987 Nissan maxima are the coolant system drain plugs and after you flush the system do the drain plugs have to be replaced?
You will have to drain part of the coolant. Try to drain as little as possible and fill up before restarting the engine. No, the thermostat is usually at the top of the engine block (placed between the top input hose and the block). If, however, the radiator is full of coolant, there will be some spillage. Also, make sure the coolant has cooled down before replacement, and do periodically replace the coolant as needed.
1. raise gas tank, the radiator cap is there, below the gas tank, open the cap... 2. remove the drain bolt on the water pump cover and drain the system coolant.. 3. disconnect the hose from the reserve coolant tank, end empty the coolant from the reserve tank, and after that connect the hose . 4. re install the drain bolt n fill the coolant from radiator cap, the drain bolt potitions on left side…