You can't fill a toilet drain not in use as there is no 'trap' to fill with water. The best thing is to get a toilet flange cover from a Plumbing store and install it on the toilet flange - i.e. the circular fitting in the floor that the toilet would normally sit on.
By simple pouring a few gallons of cold water to replenish the trap seal of the fixture .. check it every few weeks to make sure there is still water above the crown weirThe toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
Yes, as long as you seal the drain of the toilet you are removing.
The drain from the toilet to the main drain is plugged and the branch to the shower is not. If the main floor toilet flushes, it is between the two toilets and not between the house and the sewer.
It's not the toilet, there's a blockage in the pipes some where after the drain pipe from the toilet joins up with the drain pipe from the tub.You're going to need to have the pipe snaked.
partially clogged drain or vent, improperly installed vent or drain
The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
You have to use toilet more
Yes, as long as you seal the drain of the toilet you are removing.
This can be a complicated job as the toilet drain ranges from 3" -4" and a variety of materials from Plastic to cast iron to galvanized. Then there is the venting to consider and NO a shower drain CANNOT be used for a toilet discharge as the shower drain is normally 2" diameter
You just have to use a reducer to get it down to 1 1/2 or 2 inch.
Usually toilet flange is glued down onto plastic drain pipe. There is a toilet flange that can be glued inside of plastic drain pipe also.
Yes as long as the drain has a trap and is vented
On a standard toilet in America the drain is 12 inches from the back wall to the center of the drain.
12-13 inches to the center of the drain.... make sure your drain pipe is 1/4 inch drop per foot. also use the sweeping y drain if possible. leave lots of room for the flange. mount the toilet after the floor is in.
You shouldn't use any acid when cleaning your toilet. It can kill the bacteria that the system needs to break down waste.
The drain from the toilet to the main drain is plugged and the branch to the shower is not. If the main floor toilet flushes, it is between the two toilets and not between the house and the sewer.
Brasscraft is a good choice of brand.