No, they are a different part number and are different steering columns. Stick with the escort/tracer switch. No, they are a different part number and are different steering columns. Stick with the escort/tracer switch.
Begin by removing the retaining ring at the top of your 1992 Chevy ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.
Check fuses and relays. If you have power coming from the ignition switch but not getting to the starter there might be a bad fuse or relay or wire. Also make sure you have the wiring correct to the starter since you just replaced it.
Apply 12V directly to the motor and see if it works Turn ignition switch and A/C on and check to see if you are getting power to the fan motor- if so motor is bad - if not could be a bad fuse or relay or sensor switch
Simple Answer: The Ignition lock. There is a metal tab located on the tumbler assembly, which when turning the key [to start the car] presses on a switch [which turns on a relay; which kicks in the starter] This tab most likely broke off. Replace the tumbler assembly
First remove the steering wheel, remove the torx screws and remove the house, remove the signal switch and the wiper switch, remove the torx screws and?æremove the ignition switch. Put in the new switch and replace everything in reverse.?æ
1992 olds Achieva does not have that switch. ECM receive signal from the coolant temperature sensor and send command to relay #6 for turn on/off the radiator fan. Relay #6 is located in the motor compartment on the fireboard.