You need OBD2 reader or scanner to get the codes
To my knowledge, an OBDII scanner tool will read any OBDII system in any vehicle. And yes, the 2000 Mazda has the OBDII system. Incase you did not know. All vehicles sold in the US 96 and newer are required to have an OBDII system.
LOCATION OF OBD2 PORT?
where is the fault self diagnostic connector located on a mazda demio
You must reset the light with an OBD2 scan tool. Resetting the light without repairing the problem that set the fault code in the first place will only allow the light to come on again.
can anyone tell me where to find the OBD2 plug in on a 1999 cougar?
No, different communication protocol.
It's optional on the 323 so most don't have one
Just to the right of the hood release on backside of plastic covering
It's located in a small recess left of the steering colomn on the lower side of the dash.
With an OBD2 scan tool.
It should be OBD2. I think 96-00 civics are all OBD2
All OBD2 connectors on 2004 vehicles of any make are found on the left (drivers) side under the dash panel. Most have covers to protect the prongs.
Hi, Not sure about the 00 model - most OBD2 plugs are close to the central ashtray. However on my 2003 Seat Ibiza the OBD2 plug is on the left side of the car - below the steering wheel on the left is a tiny glove compartment. Remove that compartment and behind it you'll find the plug. Took me 30 minutes to find! Blaise
the diagnostics connector can be found under the passenger seat alongside the ecu. Actually that's the diagnostic, what the guy wants is the OBD2, not the same thing. That plug can be found if you feel in the middle of the dashboard above the A/C controls for a clip that unclips the whole middle center of the dash and under there you can find all the fuses and the OBD2 plug
Take out the ashtray (in front of the gear stick) and in there you will find the connector
Acura Legends do not have obd2 plugs. They are all OBD1.
yes all cars made in 1996 and newer are obd2
Did you ever get this question answered? Wondering the same thing. Check engine light is on in my 05 Mazda SP 2.3. Neighbor has a OBD2 scanner. But wants me to make sure it will work before coming over tonight. Let me know... Thanks!
Have you repaired the problem that cause the light to come on in the first place? If not the light will just come back on. You reset the light with an OBD2 scan tool.
1993 honda accord is obd1 not obd2
all cars manufactured in the us after 1996 use obd2
OBD1, OBD2 didn't start until i believe 1996