Chrysler Town and Country
Crankshaft Sensors
Ford Expedition XLT

How do you find the location cam sensor on a 1996 Town and Country van with a 3800 motor?

262728

Top Answer
User Avatar
Wiki User
2011-10-28 05:15:19
2011-10-28 05:15:19

In a '96 with the 3.8L, the cam position sensor is in the timing chain cover, near the very top. It's just below the rear bolt on the thermostat housing. If you're going to replace it, make sure that the new one comes with the paper spacer on the end. It's a little dot of thick paper (about 1 milimeter thick) that is provided to set the gap between the end of the sensor and a special disc on the end of the cam.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Which motor do you have? Normally this sensor can be found on the throttle body.

User Avatar

what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl. passenger side of engine block

User Avatar

were is the camshaft position sensor (cmp) location on a 1996 caprice classic

User Avatar

motor heat sensor where is it locasted in a 1996 aerostar ford van

User Avatar

ect sensor 1996 nissan pathfinder location?>

User Avatar

diagram of a nock sensor in a 300zx 1996

User Avatar

Bank one is usually the left side of the motor and sensor 2 would be the one past the converter.

User Avatar

where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine

User Avatar

location of relay for heated o2 sensor 1999 jeep Cherokee sport

User Avatar

That would be the sensor after the catalytic convertor.

User Avatar

By the oil filter behind the motor mount.

User Avatar

trying to locate a sensor for the theft system for a 1996 toyota camry please help someone

User Avatar

It is located in the transmission

User Avatar

The location of the coolant temperature on the 1996 Honda Passport is actually behind the alternator. You can see the sensor in any Haynes or Chilton's manual for that vehicle year.

User Avatar

i have Toyota 1996 Camry fan blow will not work what fuse make it work and location . fan motor ck out all right

User Avatar

Itis on the driver's side before the catalytic convertor.

User Avatar

were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine

User Avatar

www.motorcraft.com does not list a MAP sensor for a 1996 F150 4.9 L ( 300 cubic inch ) straight 6 cylinder They list a remanufactured air mass sensor ( mass airflow sensor )

User Avatar

Map sensor is located behind the dashboard on the passenger side. The map sensor will be adjacent to the central computer unit.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.