Replacing a thermostat on a 1999 Oldsmobile Cutlass is very easy to do. First you will find the thermostat by following the upper radiator hose. It is under the exhaust crossover. The thermostat has two 13 mm bolts holding it in place. Take the bolts off to remove the thermostat and replace with a new one.
The thermostat is located where the hose leaves the engine to go to the top of the radiator. You unscrew the bolts holding the hose mounting to the engine. There you find the thermostat.
i need an oil pump fro a 1988 oldsmobile cutlass calais where can i buy one? firstname.lastname@example.org
Find it at the engine end of the upper rad hose. When replacing it make sure the spring goes toward the engine. Looking at the engine (1998 olds.. cutlass) while hood is up. on the right hand side. Follow the large radiator hose to the engine. The thermostat is located in the metal housing under the air intake. (attached to the air filter) Not a good spot. No easy access. YOu musst remove part of the air filter system to get to it!
follow the top radiator hose to the engine the hose is attached to it with a hose clamp, there should be two three bolts holding it to the engine
maybe this will help,,, i just replaced the water pump,heater core,thermostat,battery,alternater on my Oldsmobile and found this site to be very helpful even has pictures AutoMedia.com maybe you can find your answer there good luck
You can find the 1993 Oldsmobile Cutlass block heater on the right hand side of the engine block. You can follow the block heater cord directly to the block heater.
junkyards, e-bay or craigslist.
No you can not put any Oldsmobile motor into a 1985 Cutlass Supreme. Each car has a motor that was designed specifically for that vehicle. So if you need to replace the motor in a 1985 Cutlass Supreme, you need to find the specific motor for that vehicle.
There should be a diagram there. If not go to an autoparts store and they can find out for you.
"Yes, Ford México has the same models they sell in the US, but in México the Oldsmobile Cutlass was manufactured by Ford and know as the Ford Cutlass." I cannot find ANY confirmation on this. Oldsmobile made the cutlass, and I did read somewhere that in Mexico they called it the Chevy Cutlass (which makes sense Chevy and Oldsmobile are both part of General Motors Corp.), but Ford is a whole different corporation and I don't see model names crossing companies like that.
Some engines are easier than others. Follow the upper rad hose from the rad to the engine and there you will find the housing for the thermostat. take the 2 bolts holding it out after taking the hose off and when replacing it make sure the spring goes toward the engine.
It is incorperated with the PRNDL switch on the trans.
Check out FUELECONOMY.GOVIt lets you find the MPG for any car =]
A free wiring diagram can be found in the maintenance manual of the 1993 Oldsmobile Cutlass. It may also be obtained through an auto part store, some will give a person a print off of a diagram.
I have a 1982 cutlass supreme and the diagram in under the hood on a front panel, If not someone may have removed it.
Go to the library and get a chiltons repair manual for your model.
This probably has to be ordered from the dealership as it needs to be encoded, which is proprietary information.
sad to say.but i do not know either... i have a 1994 cutlass supreme sl and am looking for the same answer. if you hapen to find the answer. i would appreciate it if you would contact me at email@example.com thanks
Follow the top radiator hose to the engine and find a bulborous part device the hose is attached to. The thermostat is inside there.
Look under hood against firewall - should be a plate with paint codes
Open passenger door. Look on the end of the dash panel for a door marked "FUSES".
yearone.com classicoldsmobile.com or Google 1967 Oldsmobile parts catalogue. also eBay motors