speedo connected to gearbox and connected to other end not brken but not working
where is the speadometeter cable on an x reg corsa
possibly $0.00c go figure!
unscrew the old one and screw on the new one . . Easy!
The speedometer cable (which runs from the transmission to the dashboard) has snapped. This is a two-piece cable, and the one-piece cable in later Proteges will not work. I had the transmission replaced, and the cable could never be fit in properly. This is a mechanical speedometer, so you would have to change the entire speedometer part of the instrument panel to use a magnetic/electronic speedometer.
locating speed detecting pinout ,as to fit a speed alert to a 2004sp23 auto mazda3
how do I fit a petrol flap to a vauxhall meriva
Your alignment on the speedometer cable is off. This happens a lot on older Geos. Take it to a mechanic and have them speed test it and re fit it.
How long does it take to fit a concentic valve in a vauxhall astra
This suggests that you have a mechanical speedometer system which uses a combination cable consisting of a rotating inner cable inside a fixed outer cable. That cable runs from some source of rotation [normally the transmission, but sometimes from a wheel, or if so equipped, a speed control [Cruise Control] device. Often a vibrating, "jumping," or "ticking/clicking" speedometer cable is an indication that the lubrication [grease or other form of lubricant] between the inner and the outer cable has failed. Mechanical speedometer cables usually are attached to the source of rotation, and the back of the speedometer, with threaded screw-on connector rings. The ends of the inner cable are usually "squared" to fit into square openings inside the speedometer and the source of rotation. If failed lubrication is the cause of the symptom you describe, then the "fix" is to locate the cable, disconnect one end [the easiest is usually the opposite end from the speedometer in the instrument panel] pull the inner cable out, clean and lubricate it, reinsert, and reconnect the outer cable. NOTE: The squared ends of the inner cable must fully insert into the matching square holes in the speedometer and rotational source, so it is necessary to slightly rotate it while reinstalling the inner cable. If it does not properly "mate" with the square opening, then it will stick out to far to allow reconnection of the outer cable from where it was removed.
any engine will fit just about in any car. you will need new motor mounts, tranny, rear end, driveshaft, wire harness, and speedometer cable.
This speedometer is for dyna glide wide 1995.
How to fit clutch cable on a daewoo cielo