Get amanual on your car.
It depends on what is wrong with them
i have a 2000 mazda 626 with a 1744 code. i was able to pull the code but my scanner wont tell me what it is for. what does this code represent and how do i fix it?
you dont
buy new motor
My 1991 Mazda 626 will start and idle fine but when you put it in gear the HOLD light flashes and the car will not move almost as if the tranny is shot but its NOT the flashing hold light indicates that there is an electrical problem with the tranny but my question is is there some kind of reocuring problem with this year and model if so how do i fix it
if your not a mechanic stop googling ways to fix your car and take it to a professionial.
Generally whenever a switch goes bad the only thing you can do is replace it.
well trans fluid in all the cylinders will work or a rebuild
I had a 1994 and it was pretty easy. If you open your trunk, on the right (or side with antenna) you just pull back the carpet stuff and you can then unplug the old antenna. You can get one fromthe junk yard, or one from the store and just wire it in. The factory one from the store is quite expensive, i just bought a cheaper one and wiredit in. Its easy. The other one just comes right out when you disconnect it.You will see how to do it once you look.
just replace the whole caliper.
The engine code P0355 is for a malfunctioning ignition coil. This can be fixed by replacing the coil. It can be purchased at any auto parts store.