Headlights Tail and Brake Lights
Dashboard Lights and Gauges
Mitsubishi Lancer
Turn Signals and Hazard Lights

How do you fix a 1990 Mitsubishi Lancer indicators when they flash quickly but all the lights work?

262728

Top Answer
User Avatar
Wiki User
2008-05-29 20:57:53
2008-05-29 20:57:53

it means that one of the indicator blubs have blu which causes them to flash quickly

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It sounds as if you have an electrical problem that needs to be checked. You may even have the wrong fuse for your brake lights.

User Avatar

to change the lights you remove the dash cluster and replace the bulbs. the number for the bulbs are 197

User Avatar

It requires more power, RPM goes down when demand for power is higher especially if lights are on or air conditioning

User Avatar

Turn signal indicators are lights. The flash to tell you, or indicate, that a turn signal is on, and which way the lights are flashing.

User Avatar

the fuses which opperate the brake lights are located in the fuse box in the engine compartment. the relays are to the left of the clutch in a white connection cluster.

User Avatar

where does the yellow wire with a black stripe on it connect for dimmer lights,panel lights,and gear shift lights,for a 2000 Mitsubishi galant

User Avatar

your signal light is burned out. The rear signal lights burn out quite quickly and the fast flashing is an indicator you need to replace them.

User Avatar

my indicators have stopped working checked fuses in fuse box my hazzard lights still work

User Avatar

On the lancer its easy just pop the trunk open find out which lights are out and take the screws out that hold the lights in place and pop the bulb out that isn't working by turning it and replace it.

User Avatar

There are several dash lights on a Mitsubishi Triton. There is a light to indicate a hot engine, low battery current, high beam lights and when the cruise control is engaged.

User Avatar

what the dash lights mean on a mitsubishi canter 35 3 litre

User Avatar

How do you disable the DRLs on a 2005 Mitsubishi Endeavor?

User Avatar

If dome lights and sunroof of a Mitsubishi Galant are not working, it is probably due to blown fuse. It is time to replace old ones.

User Avatar

Test if your hazard lights work. There are normally two flasher cans in most vehicles. If the hazard lights work, It is likely to be the flasher can that works the indicators is blown and in need of replacement. These will be available for under $50US from most auto parts stores.

User Avatar

The wiring diagram for the fog lights of the 2001 Mitsubishi Mirage can be found in the maintenance manual. It can also be found in the repair manual of the car.

User Avatar

The dashboard lights on a Nissan are indicators to help maintain the safety of the vehicle. These lights let you know when you are running out of gas, oil or if you need to have your engine checked.

User Avatar

If you leave the indicators on when the ignition is off the sidelights or parking lights will be turned on. Just an alternative to leaving all the parking lights on in order to save battery use. Eg if you are parked in a poorly lit area for a while.

User Avatar

No they did not come factory equipped with daytime running lights.

User Avatar

Break lights come on when you step on the break, they do not come on when the head lights are turned on.

User Avatar

you have a short circuit, see a auto sparky

User Avatar

The warning lights are warning indicators meant to indicate something being wrong. When the lights turn red, it means it is in immediate need of attention.

User Avatar

Match Lite charcoal lights quickly and burns good.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.