Replace the chain and both the cam and crankshaft gears.
yes and only way to fix it is to replace the sensor
To fix a window that won't roll up on a Ford Probe, the door panel will have to be removed. The cable for the window will have to be restrung onto the pulley or a new one will have to be installed.
The only fix is to replace the gaskets. Also check to make sure the head is not warped or cracked.
really bad spark plugs probably could fix with bj weld
It is the engine speed curcuit that is malfunctioning. Replace the Crankshaft position sensor.
you cannot fix the timing on your tbird as it is electronically controlled and does not have a distrubutor. have your camshaft or crankshaft sensors checked
i have a 95 probe gt 2.5l with a bad head gasket and it overheats if driven longer than 5-10 min tops idk how to fix it though hope this helps
Replace the bad injector.
A damaged crankshaft will need replaced.A damaged crankshaft will need replaced.
It could be a few thing's. 1.bad coil 2.bad fuse 3.short in the wire 4.bad crankshaft sensor... I had the same problem and it turned out to be a bad crankshaft sensor it is about 60 bucks for the part and 5 minutes to fix it.
Turn the brightness control up. Could be the reset button for the odometer or another switch.
e350 is bad that's why
I suspect that the sender is bad or the wiring to it. The fuel sender is mounted along side the fuel pump which is located in the fuel tank. If your pump was just replaced maybe the sender was damaged in the process. It may just have gone bad also.
locate the crankshaft sensor which will probably be behind or right next to the crank shaft which is under the timing belt cover you might have to take the cover off and the timing belt
No. If you want it done right, you better expect to put some real work into it. No simple solution will fix your problem. I speak from personal experience. Sincerely, the girl who is changing the starter on her own 95 Ford Probe SE
you sell the ford and buy a Chevy
if they flicker then most likely another turn sigal on the same side is bad or the bulb is blown
check that the coolant fan is turning check coolant flood check if thermostat is stuck chec water pump gotta be one of the 4
check the sensor on the door, its probably bad
You either have a bad relay, wiper motor, or bad switch.
PO335 Crankshaft Position Sensor Circuit.Possible causes: Faulty crankshaft position sensorLoose or shorted wiring to sensorSignal plate damagedBad starter motorWeak battery
probably a starter motor problem. Could just be a battery cable. They go bad a lot in 93 Probe. I've had to change my positive and negative. Very cheap problem to fix. I would check the ground to make sure It's grounded good to motor and battery. and inspect wiring.
Code P0304 on 2000 Ford Ranger is: Misfire at cylinder 4 detected. May be cause by a bad spark plug.
Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.