answersLogoWhite

0


Best Answer

It sounds like you need to replace the crankshaft position sensor! If it is bad you will not get any spark.

User Avatar

Wiki User

โˆ™ 2008-11-29 16:34:34
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you fix a buick regal 1996 that has no spark the fuel pump and filter and ignition control system are new?
Write your answer...
Submit
Related questions

How do you change ignition control module 1995 Buick Riviera?

Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.


1995 Buick Roadmaster Control module location?

Under an air filter


What causes no spark in a 1988 Buick lasabre?

Crank sensor has failed,Ignition control module (ICM) has failed,Bad ignition coil pack,


Replace ignition switch for 1993 Buick century?

Replace ignition switch for 1993 buick century?


Where is and how to you relace ignition control module 1996 Buick Riviera?

In the distributor, buy a new one and read the instructions


How to replace 1996 Buick Skylark Ignition?

Ignition what? Switch? Coil?


Where is the coil wire on a 1995 Buick Riviera?

There is no coil wire. There is a coil pack and connected to the coil pack is the ignition control module.


What is The Wiring position for the ignition module on a 1990 Buick park avenue?

what is the wiring position for the ignition module on a 1990 Buick Park Avenue?


Where is the fuel filter located and how do you replace it on a 2003 Buick Regal?

How do you replace the fuel filter on a 2003 Buick Regal?


What does trac off light mean on a buick century?

When the trac light is off, on a Buick Century, the traction control monitoring system is disengaged. It is recommended to have the trac system engaged on wet roads.


What does code P0446 for a 1998 Buick LeSabre mean?

P0446 Evaporative Emission Control System Vent Control Circuit Malfunction


Where exactly are the ignition fuses for 1993 Buick regal limited 3800?

The ignition fuses for the 1993 1993 Buick Regal 3800 is located on the car's dashboard.


Buick evaporative emission control system malfunction 0440?

http://www.obd-codes.com/p0440


How do you replace the fuel filter on a Buick LeSabre?

How do you replace fuel filter on 1993 Buick LeSabre, the replacement filter I bought appears to be a snap on. I have only replaced the screw on type.


Where is the fuel filter located on a 1990 Buick Skylark?

The fuel filter is located near the rear of the vehicle, forward of the fuel tank.


Why on a 1992 Buick Park Avenue the heater fan motor will not shut off with the ignition switch?

The problem is most likely a faulty blower control module.


What is PO452 code for 99 Buick Century?

Evap Emission Control System Pressure Sensor Low


What happens when a 89 Buick reatta fuel filter goes bad?

What happens when a 1989 buick reatta fuel filter goes bad?


Why doesn't my buick reatta have ignition spark?

check your plug wires, then your coil packs, then your ignition module.


Where is the oil filter on 1992 Buick Century?

On a 1992 Buick Century, the oil filter is located between the radiator and the lower front of the engine. The radiator is situated in slightly in front of the filter.


How do you change the air filter in a 2005 Buick Century?

There is no such thing as a 2005 Buick Century


How do you time a 1999 Buick LeSabre?

There is no adjustment for ignition timing.


Does a 1978 Buick regal have a cabin filter?

No.


Where is heater control valve on 1994 Buick regal?

Where is the heater control valve on a 1994 Buick Regal


How does the ignition cylinder come out on your 91 Buick century?

Remove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.