how do you fix a prosthetic leg that the release screw wont go all the way down in to the socket
Remove door panel and replace latch mechanism
That would depend on why it is stuck. If the problem is with the latch mechanism assembly, you have to remove the door panel from inside the car ( loads of fun with the door shut) and pop the latch open from inside. If the door is simply stuck shut because it's jammed on something, from the inside of the car, hold the door handle in the release position and kick it open without damaging anything.
install a new latch
sounds like a bad door latch mechanism.
Get a new car you loser.
sunfire drivers door latch won t work
On many vans/cars I have seen the latch on the door itself sometimes get tumbled into the shut position on accident. In most cases all you need is a screw driver to put into the latch hole on the door itself while pulling on the door handle simply flip the latch back open. If this is not the case please clarify your question. The door jam has a male stiker the door latch is female or should be open to allow the striker to go inside it once the door is shut the latch wraps around the striker.
Remove the side panel and manually depress the plastic latch on the tape cassette. Remove the cassette and shut the door again. You may have to push the latch a bit to get it to close right.
Just going by the question...I would say that the latch has gotten in "the closed door position". Be sure that the door is unlocked. With your finger lift out on the latch on the end of the door and use the door handle to "open" the door latch.
door open from inside or outside
buy a new oneANS 2 - You can always adjust the strike plate OR the latch so they meet properly.
My husband fixed ours with a window latch, it cost 3 dollars, he put it by the door handle, the swivel part on the door and the latch part on the dryer. When you close the door you latch it shut. It has never opened again. So nice.