Try replacing the hinge pin bushings. Common problem on these trucks.
Access in rear door panel, allows you to lock/inlock rear door.
Check the fuse.
Close the door but first put a chemical by your do so they wont bring friends.
Its when a door wont close without a little pushing, because the hinge has been cut to deep into the door frame . lots of love steve .
try to close it then never use it ...if i could keep it closed i wont open it again i think it has something to do with the mechanics in the door itself
no it wont hurt the jimmy
make sure your door shims are not worn out,....open the door half way and lift the door up, if you feel slight movement or looseness in the door you may have to replace the shims
usually the locking latch in the door is in the closed position. try holding the handle in the open position and opening the latch manually.
needs electric motor located underneath glass, behind door panel.
if your door wont close then i would look at the "eyes" but if it wont open or close check the wires take it wall unit off and make sure the wires are hooked up. I just learned a costly lesson and that you need to check the power. Are your red beams lit up? Check your trip switch. That's a $60 lesson and I hope I can save someone else a service call perhaps.
Try checking the switches on the door frames. The switches are spring loaded; when you close the door it breaks the contact. Start with the driver's door. The driver's door receives the most use. Also: the switch can break and fall into the door pillar.
Fod product? Spray the door latch assembly liberally with WD-40, operate the door a few times then spray with a silicone spray