Top Answer
User Avatar
Wiki User
Answered 2010-11-02 01:16:50

putt More water in the bowl

User Avatar

Your Answer

Still Have Questions?

Related Questions

Why will toilet fill with water but won't flush?

because it is clogged If a toilet has a blockage it will over flowWhen you say the toilet will fill are you talking about the tank?

Why does your toilet take so long to fill after a flush?

The toilet may take so long to fill after you flush because the water pressure is so low. Generally, the water should fill up the tank in less than a minute.

Once you flush toilet water don't fill up?

It sounds like you are ready for a flush valve replacement.

Why is there already water in toilet bowls?

Under what circumstance? New toilet, when you turn the water on, water goes down the overflow tube to fill the bowl. You don't have to flush it the first time to fill the bowl.

Why do you fill a bathtub with water to flush a toilet?

Most people don't. If you do then visit a doctor or have a plumber call.

Can you increase flush in water saver toilet?

Yes, adjust the fill valve, different ways for different types.

Why does the toilet bowl not fill up all the way after a flush?

Inside the toilet tank there should be a small hose off of the fill valve that should be clipped to the inside of the fill tube to allow water to fill the bowl while it refills the tank after flushing.

Why doesn't the toilet bowl fill after flush?

Refill tube not connected /working.Float valve stuck or water turned off

Why does my toilet flush and leave no water in the toilet bowl?

It sounds like you need a new ballcock valve or either your fill tube has come off your flush valve. Just take tank lid off and check to see if water is going down the tube in middle of tank.

What is wrong if the sink and the bathtub will drain but the toilet wont flush?

The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.

Why does my toilet cistern take a long time to fill after I flush?

Probably because your water pressure is very bad or because the inlet is somewhat clogged.

How much is the toilet cistern cost can it be DIY?

Toilet cistern can cost a lot since it is the most used water in the house. But there is some ways to reducing the amount of water your toilet is flushing. First fill a half gallon container with water, place the container in the tank of the toilet, lower it in to the water, replace the lid and then youÕre ready to flush.

What causes the toilet bowl not fill all the way up after flushing?

That means that your toilet is clogged, or your toilet was clogged and you need to just flush once more.

Why does the toilet tank stay empty and not fill up with water?

Do you watch it not get filled up? There is a little hose inside the tank that helps fill the toilet when the tank is filling. It may be detached from the vertica pipe. < --- this answer is for the bowl not filling up after you flush the toilet There can be many reasons why the tank will not fill up and one of them can be because your chain that pulls the rubber flapper up to flush is either caught on something or the rubber flapper can be pulled to high and will not fall back down to close. Another is if you have a plastic cone flapper then the flush handle bar that slips into the plastic cone sleeve can be wedged against the toilet tank. another reason can be because your fill valve is clogged or the water is shut off.

How do you turn pressure down at toilet flush valve?

If it's a normal household toilet you simply lower the water level in the tank that's over and behind the toilet by adjusting the fill valve. There are many different designs so I can't tell you how on your particular toilet. Some ae as easy as turning a plastic screw and some are a real pita. If you adjust it and raise the water level too much water may run over into the overflow tube and it will just keep running. If you lower it too much your toilet may not flush completely. Generally I adust mine as high as they will go without overflowing in order to get a stronger flush. I have never needed or wanted to turn down a flush.

Why does the toilet continuously flush after filling?

The fill valve flap is defective, causing the water to leak out. The fluid master that alllows water to enter the tank is jambed,defective or worn out and needs to be replaced.

How does a toilet tank fill up with water?

there is many different toilet tanks that use different fill valves but the concept is the same EXCEPT for pressure assist or (mostly in commercial buildings) flush valves which do not have toilet tanks. When water flows into the tank threw the open valve it begins to fill up the tank and while the tank is filling it is also raising the float which is connect to the valve and when the float raises to a set height it shuts of the fill valve by pressure from the float arm. Pressure assist toilets have pressure tanks inside the toilet tank and uses the pressure from the supply line to flush the bowl, I think they are the best toilets to buy if you don't mind the noise and if you have good water.

Why has the water from bath sink fill toilet but toilet has no pressure to flush properly water drains out but does not flush?

Up along the rim of the toilet there are little holes that pour the water out when the toilet is flushed. Check the holes, they get clogged from build up over the years... Use a paper clip to clean them out.... A dirty job but could save you some $ replacing a toilet. You can check to see if that's the problem by filling a bucket with water and pouring it into the toilet. If it "flushes" correctly then it is not a drain line problem and is a problem with the water getting from the reservoir fast enough... that is likely the holes are clogged or you need new reservoir components.

What do you do after you fill up the bathtub on shrink ray island?

push the sope across the water to the left side and jump on the rubber duck and jump out. Then flush the thumbdrive down the toilet.

Kohler powerflush toilet will not fill tank?

Check the flush valve to see if it is sealing tight. Check the fill valve to see if it needs to be rebuilt or replaced.

What to do if your toilet won't fill up with enough water in the toilet bowl?

look inside your tank and see that the toilet bowl fill tube is connected and flowing with water when flushed. the fill tube is a 1/4-3/8" tube that is connected to the fill valve to the overflow and it should be spraying water down the overflow when the fill valve is filling. or Call a plumber

Why is your water control assembly on your toilet like a fountain when you flush?

If you are referring to the water closet fill valve, then you probably have a bad seal. most Ball Cocks fill from the bottom and have a feed line to the bowl. If the seal in the top of the valve near the ball arm is bad you will get water out of the top of that valve. If the line (usually a small hose that goes in to the top of the flush valve) is off it, will also spray water. sounds like the fill valve is bad and should be replaced. A fluid master 400 will fit most toilets and is easy to install. The amount of water in the bowl after flushing is very important to a good flushing water closet. if this hose does not stay in place the toilet will flush slow and clog up more.

What is a camping toilet Where can I buy one?

Basically a camping toilet is a portable toilet that is not connected to the mains. From researching this online the most reliable source that I could find that I have used is Amazon. They currently have a 5 gallon portable toilet at half price. This one you fill up with water and flush it like a normal toilet which may make it easier to use. It got excellent reviews.

Still have questions?

Trending Questions
Unanswered Questions