First you need to identify the cause of the miss. Whether it be fuel or ignition.
Follow fuel line from tank
The safety fuel shut off location on a 1991 Mazda MX6 is under the dash. It is on the far right side in front of the passenger seat.
There could be many reasons why a 1995 Mazda MX6 is not starting. Some of the reasons could be a bad alternator, starter, battery, or fuel pump.
mx6 got no moonroof - only a sunroof and YES its interchangeable
There is no pressure outlet to check,you have to buy a fuel pressure gague kit or take it to a shop to have it checked. If you buy a kit you have to unhook the fuel inlet hose and fit it to the gauge to see what the pressure is reading.
5lts or just over 1 gallon
Either the fuel pump isn't working properly or the fuel filter is plugged.
Take out the old ones and replace them with new ones.
on the driver side you have to remove the intake hose, follow the fuel line going to the fuel rail and you'll find it.
The fuel safety switch in a 1994 Mazda MX6 is located on the inside of the fuel tank. This is very tricky to locate, so it would be better to leave it up to the professionals toÊmaintain.
If you have the standard 1995 Mazda MX6 then it came OE with P195/65R14... I hope this has helped. COO of TireTyre.com
The fuel pump relay switch, on your Mazda automobile, is located on the outside of the gasoline tank. The relay switch will be just above the fuel line.
mx6, 626, capella, ford probe, telstar, tx5
stock wheels on the first gen mx6 is +44 for the 15x6 wheels.
I know if you have an auto transmission v6 Mazda mx6 93. You can put the transmission fluid in a 1993 Mazda Mx6 v6 from where you check the dip of transmission fluid. It is located close to the battery and close to the fuel filter. Its cap is orange color. For the manual transmission, you have to look under neath of the car, there is a bolt for drain and a bolt for to fill. Look around it, you will see it.
Open the Dash at the bottom and then look to the bottom left of the relay panel
That one over there parked by the Honda.
Mazda produced the MX6 automobile for the first time in 1987. They then released the second generation model in 1991 and this was in production until 1997.
listen....all voltage at the fuel pump needs to be 12 volts. period. u may have 7.25 to 7.5 volts reading at the fuel level gauge sending unit. all pumps require 12 volts to operate
This is done the same as the 1995 Mazda MX6. The answer is posted.
go to yahoo groups. sign up for a yahoo email account if you don't have one, then join the yahoo Mazda mx6 group. Here you will find all kinds of files and manuals on Mazda mx6, to include manuals , wiring diagrams, schematics etc. Please note to other members that you were refered by ebonyleg. groups.yahoo.com/mx6
yes, the 626 and mx6 are interchangable maybe diff wiring but the same