0
Pretty easy, there are holes inside and in the back of the flare that match up with holes in the steel fender, mounting hardware is screws from inside the fender to plastic nuts inside the flare, but any nut and bolt that will fit through the hole will work, you may need washers on the flare side though.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What holds the fender flare together on a 2003 Jeep liberty?
Fender flares on most vehicles, including the 2003 Jeep Liberty, are held together by pop rivets. Some vehicles might use a rivet that can be turned with a special square-tip screwdriver to remove it.
How do you get a fender flare back into the fender retainer on a 2001 Jeep Cherokee Sport?
I have the same problem... the metal tabs have to be in the right spot and you should be able to just pop it back on. I know on the bottom there is a hole where you need to pop it in on the bottom (on the rear). I just lost a flare on the road tonight so I have to order some more... :(
Can fender flares from a 97 Jeep Wrangler tj fit on a 97 Jeep Wrangler?
Yes.
What oil does a Jeep Wrangler 1988?
on a 6 cylendar 1988 jeep wrangler what viscosity oil is used
How can you tell if your freeze plugs have popped out on a 94 jeep Cherokee?
Your engine will overheat, rapidly if they have 'popped out' (on any vehicle, incidentally) because all the anti-freeze will leak out.
Will a soft top from a 1994 jeep fit a 1988 jeep?
Yes
Can you put the fender flares back on once you remove them on a 1999 Jeep Cherokee Sport?
Double sided tape Sheet metal screws Pop-Rivets Yes, I've had the same problem with my 2000 Sport. I just got them to go tight against the body last week. Locate the 5 or 6 bolts just inside the fenderwell. Spray them with penetrating oil! Wait a few minutes then use a deep, metric socket to unscrew nuts. Some bolts might have flare keepers. Pull them off first. Watch out, their sharp. After backing off nuts a little, fit fender in between brackets and body of jeep aligning tabs on fender to tabs on brackets. Tighten nuts and slip those flare keepers back on-if any.
Where is the voltage regulator on a 1991 Jeep Cherokee?
The engine computer is the voltage regulator on a 1991 Jeep. It is mounted to the inner fender, under the hood.
Does a 1996 Jeep Cherokee finder fit on a 1999 Jeep Cherokee finder?
if you mean 'fender', then no. the Cherokee body style changed in 1997
Where will the tires rub if the tires on a jeep are to big?
Inner fender, axle, or steering component.
Where is brake reservoir in 1995 Jeep Wrangler?
Drivers side firewall/ fender area
Will a AW4 trans from a 1991 Jeep Cherokee fit a 1988 Jeep Cherokee?
An AW4 transmission from a 1991 Jeep Cherokee will not fit into a 1988 Jeep Cherokee. The transmissions in the varying years do not appear to be compatible with one another.
