Best Answer

Is the replacement an LED bulb being used with a flasher module designed for an incandescent lamp? LEDs won't activate the load sensing circuit, so the module never initiates strobe. -Galen

User Avatar

Wiki User

โˆ™ 2015-07-15 21:10:27
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you fix a turn signal that you put a new bulb in but it does not blink and just stays lit when lights are on?
Write your answer...

Related Questions

Your signal lights come on but dont blink on my impala?

You either have a bulb burnt out or the turn signal flasher is bad.

How do you fix a turn signal when the hazard lights blink left turn signal blinks but when using right turn signal it just stays solid.?

It means that a light bulb is out on the side where the light solid (not blinking) it could be in the front or rear of the vehicle.

How do you fix a turn signal when the hazard lights blink left turn signal blinks but when using right turn signal it just stays on on a Dodge Dakota?

Sounds like you simply have A burned out bulb, Turn the signal on and look at all the lights to see if any are burned out. Could be A marker light if its in the turn signal circuit.

What turn signal bulb needs replacing in my 1992 Olds Cutlass Cruiser when right turn signal does not blink but just stays on?

You have a burned out bulb on the right side. Even a the side marker bulb will affect the turn signal

How do you fix a turn signal that stays lit but doesn't blink when lights are on?

Just replace the bulb. They stop blinking when the bulb goes bad. Usually if a bulb goes bad it will blink rapidly. If it stops blinking entirely or blinks only sometimes your flashing relay may have went out. It's a small box under the steering column usually.

2002 ford expedition front turn signal blink to fast and the rear signal don't blink at all?

your rear bulb is blown - replace the bulb The turn signal blinks fast because the bulb is going out. That is also why the others dont blink.

What is wrong with a 93 Cutlass Ciera left turn signal that will only will only turn on - not blink I have replaced the bulb and other lights work The right signal will blink like it's supposed to?

Maybe a short somewhere...did you replace the flasher unit? No - it was blinking spuradically(?) - now I have to blink it manually and it won't blink at all with lights on.

How do you fix a turn signal when the hazard lights blink left turn signal blinks but when using right turn signal it just stays on a 1986 mercury Grand Marquis?

AnswerPossible a bad turn signal flasherYou more than likely have a blown bulb. if the flasher was bad the left side indicator on the dash would not blink. do a quick inspection around the car with the left side on and then the right, you will notice which bulb is blown.Hope this helps."85MGM"

I knicked the front driver side signal on my Dodge ram replaced it back in and it works but won't blink It just stays solid is it Flasher Bulb?

If the bulb is the correct one and the other side of van lights all flash, then it is not the flasher. Check front and rear bulbs on the side that stays solid. Could be bad parking light or taillight bulb. Hope this helps.

What could be wrong if your left turn signal turns on but does not blink but the right side works?

If you mean that the arrow inside the dash turns on and stays on then your problem is one of the left side turn signal bulbs. Test by turning on your four way (hazard) lights and observing all lights. The one that does not flash is the bulb that needs replacing.

1980 camaro your turn signal stoped working the lights just come on and dont blink?

Either the front or rear bulb is burnt out.

Why does a Miata Signal lights blink fast but will not reflect in front flashers why?

check your bulbs, this happens when a light bulb is burnt out good luck

Turn signal not blinking for 2004 RX 330?

If your light is solid 1 bulb is burned out or if no lights blink it is a flasher located in your fuse box

Why does my 99 escort zx2 blinkers blink to fast?

Check all of your blinker lights. There are two in each tail light, one in each center signal, and one at the corner of each headlight, a total of 8 lights should blink when you have the flashers on. If a bulb is burnt out, it will increase the blink rate. Also, installing LED's in the tail lights will cause the blink rate to increase.

What causes the dash lights to blink when you turn on the turn signals on a 1999 Chevy Malibu?

An open ground or a short to ground when the signal is on. Usually a bad bulb.

What is wrong with your directionals if the green light on the dash stays on and does not blink?

Check the following...........turn signal bulbs front and rear, and brake lights, probably a burned out bulb or a bad connection due to corrosion in the bulb socket, finally check the turn signal flasher, under the dashboard, if the bulbs turn out to be OK. To control corrosion in bulb sockets use a di-electric grease that seals the socket to bulb connection and repells water.

On a 1997 Ford Ranger if one turn signal bulb burns out will this cause the signal lights not to work along with th Hazard warning lights?

No. Only the one bulb will stop functioning. All hazards and other bulbs will continue to function. However, if one bulb is burned out it will cause the indicator on that side to blink faster, indicating that there is a problem.

The left turn signal on a 1996 Buick Lesabre does not blink when activated The inside arrow stays on and the outside light stays on but no blinking Whats wrong and how can it be repaired?

That usually indicates that one or more of the bulbs have burned out. Turn on the left signal, get out of the vehicle and see which bulb is NOT turning on. Replace that bulb and the signal should work again. Also the flasher may not be working for one side.

What to do about the turn signal lights in the dash staying on and the turn signals dont work?

Typically if the turn signal lamp on the dashboard stays on (i.e. does not blink), it means you have a burned out turn signal bulb on either the front or rear of the car. This is especially true if it happens only on one side (i.e. left or right turn signal). If the problem exists on both sides of the vehicle, check your flasher unit.

Why does the left turn signal on a 2000 Audi A6 blink rapidly?

Bulb is burned out.

Why my signal lights are not blinking?

is the car on? do you have the signal on? is there a bulb? are there wires connected to the bulb? or just go to a mech and have him figure it out. simple.

Why would a new bulb cause the turn signal to blink fast?

The new bulb is already burned out, not seated properly in its socket, or you replaced the wrong one. Get out and look at the signal lights while they are blinking fast. Either the front or rear light is not blinking at all. That is the one that needs to be replaced.

Fast blinker turn signal?

often the blinker is made to blink faster when there is a bulb burned out

Turn signal bulb stays on but does not flash?

If it's only one side it usually means that there is a burned out bulb somewhere.

2002 ford expedition front turn signal wont blink and the rear signal blinks fast?

Change the front turn signal light bulb. It's bad.