Leave it to an Audi tech, there are many things that have to be removed. If you are doing the water pump, you may want to have the timing belt, rollers, thermostat replaced as well.
how do you fit a new water pump on Audi a6
It is behind the water pump on the side of the block. It is easier to jack up the front end, remove the wheel on the side that the pump is on and go through that way. Once the pump is off it is right behind it.
typical Audi problem. The water pump is stuffed. Impeller is free wheeling on its spindle. $$$
The Audi a4 water pump is not that hard of a job for an experienced technician. At my shop we charge about 6 hours labor for the timing belt, water pump, tensioner, tensioner pulley, and idler pulley. -- All these things should be replaced at the time of the water pump. Only one special tool is required; it is a bar used to hold the cams in time while the belt is off. If you are not an experienced tech, I would not recogmend trying to perform the job. One small mistake and you could end up with bent valves, assuming you have the 30v model. .
The water pump on a 1993 Audi 90s is located on the front of the engine. It is positioned behind the cooling fan and alternator.
Yes, it is. If you read the answer to replacing a water pump on an A4, with a 2.8 litre, it will explain how to do it.
05 Audi A6 with the 3.2 V6 water pump parts and labor aprox $750.
takes about an hour you access from under rear seat.. unit fitted to fuel tank...check FUEL PUMP RELAY first ....
Where is the water pump???
This is an extremely difficult fix. If you must know, you have to remove the front bumper and radiator. It is on the left side when you are facing the car.
Mounted on top and inside the fuel tank.
Remove the belt from your 1998 Chevy 1500 water pump. Remove the water pump return hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
how do you remove a water pump on a 1998 buick park avenue?
can you give me instructions on changing the water pump on a 1998 jeep classic 4.0.
All these here should be replaced as per post somewhere else: timing belt, water pump, tensioner, tensioner pulley, and idler pulley
it may be in fuel tank,but first check fuel lines and see if it's along the frame. they seem to go out.
it is pretty hard job. you have to remove front bamper, dump coolent, remove radiator, serpent belt, timing belt before you can reach your water pump. you have to have some special tools to work on it . try to search some topic from audiforum, you can find something really detail.
Its not that bad u don't have to remove bumper on the a6 its got plenty of room. Just use Audi timing tool if you're worried about timing otherwise if you're experienced its not that bad everyone makes it sounds worse than it is.
Drain the water from your cooling system. Remove the belt from the water pump. Remove the water pump return hose. Remove the water pump retaining bolts. Reverse the process to install your new water pump.
Remove the water return line from your 1998 Chevrolet pickup truck water pump. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
how hard is it to replace a water pump on a 1998 chevy venture van?
Drain the water from your 1998 Chevrolet S 10 cooling system. Remove the water pump return hose. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
The water pump for a 1998 Cadillac catera should be on the front of the engine. It is located near the center.
To remove a water pump from a 1998 Ford Windstar 3.0, you will need a tool called a tensioner. Disconnect the radiator and water hoses, then remove the water pump assembly.