Just replace it, it's not expensive.
Defective ignition switch.
Put an awl in the small hole under nieth of ignition switch,push up, with the ignition in the run position with vehicle off. Pull out in same positon and install new one in the run position.which is same position you will pull out old one.
ngk br8eg
Here is the wiring diagram:
remove lower covers under steering wheel, two screws are hidden behind heating and ac trim panel. remove the bolts to the bracket holding the steering column up. lower the steering column. the switch is located on the steering shaft underneath the dashboard instrument cluster.
The 1992 Dodge Ram 250 ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
You drill out the exsisting ignition switch!!
I believe it is - 1,8,4,3,6,5,7,2 on a V8
No, a 1994 Dodge Van is OBD I. It uses a different scan tool and connector.
Defective ignition switch.
4485 lbs
Check your underhood sticker.
It is probably caused by the ignition switch internals shifting (I had a similar problem before) and it turned out to be the ignition switch)
The pressure regulator is part of the pump.
the brake light switch is on a bracket just above the brake pedal.
jack is under the hood on passenger side
when u turn the ignition to run ,look under the key switch thee shoud be a small hole stick a small Allen wrench or something n itll pop out n u can switch ignitions