P1776, solenoid switch valve latched in low/reverse position. The usual cause is dirt in the transmission valve body.
P1776 how do I fix
How do you fix that problem
P1776 : solenoid switching valve latched in the low reverse position.This code has to do with a valve in the valve body of the transmission not moving properly. The dealer may have a software fix for the computer, or the valve body may need replaced.P1776 : solenoid switching valve latched in the low reverse position.This code has to do with a valve in the valve body of the transmission not moving properly. The dealer may have a software fix for the computer, or the valve body may need replaced.
You have to fix the problem that caused the trouble codes that put it in limp mode.
There is a problem on the engine or transmission. One of the sensors sends a code to the computer and this code is store into the memory. You can use this information to fix the problem To find the errror you have to turn the ignition on and off 3 times. Chrysler calls this key dance ON-OFF-ON-OFF-ON. The code with the problem will be display on the cluster. Write it down and check the code.
P0303, cylinder #3 misfire. Check plug, wire, coil, etc.
You have to repair the cause of the code that put it in limp mode.
P0720 Output Speed Sensor Circuit Malfunction
Sometimes this fault code is because the gas cap wasn't properly tightened after the last fill-up. Re-tighten the gas cap making sure it clicks three times. I think the engine light will go out on its own after 25 starts.
You first need to have it checked for codes, you then fix the cause of the code, you can then clear the code with a scan tool.
Usually, the switch has failed in the leftgate handle. The entire emblem/handle will need replaced.
If there are no exhaust leaks or other codes, the catalytic converter has failed. You will need to replace it.
Check all your wiring for your map sensor, if ok replace the map sensor.
If you are asking about a code for internal controller failure, you need to replace the controller.