Most likely is to replace the cruise servo. Two vacuum lines, three screws, one linkage and one electrical and you are done. 10.00 from a junkyard or 90.00 from an online store and about 20 minutes of labor.
speed sensor
yes. they sell them on the internet
The first models of Chevy cars to have cruise control installed was the Chevy Volt (2011). This control is a remote vehicle start-up system that makes it easier for the driver to remain the same speed for a fixed amount of time.
Alot of cruise control units have a vacuum line going to them. Check this line see if there is any leaks or such.
No. The cruise control will maintain the vehicle speed you have selected.
When you get to speed you want to keep, press the button to activate cruise control. You will on the dash light showing that cruise control was activated. After that pull the cruise control joystick down to set the speed. If you pull toward you it resets the current speed.
If it has one, it will be located in the tail stock on the left side of the transmission. If your speedo is broken, usually it is the cable that has failed. And, if it has cruise control, the section from the cruise control to the dash would be bad.
To use the cruise control on the PT Cruiser, turn the cruise control on in the steering wheel. Accelerate to the desired speed and push in the end of the left turn signal knob. The cruise control should then control the speed. To take the car out of cruise control, a person can tap the brake.
There are several things that can cause your 2003 Dodge Ram cruise control not to work. The most common cause is a blown fuse. A malfunctioning speed sensor can also cause the problem.
Speed control is Chrysler's name for cruise control. The speed control relay on your Wrangler supplies power to the vacuum servo for the cruise control. This servo opens or closes the throttle plate in the throttle body based on commands from PCM when your cruise control is set.
cruise control
The ECU has a cruise control speed limiter that will not allow the cruise control to be set after that speed has been exceeded.