answersLogoWhite

0


Best Answer

Replace the leaking part.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you fix leaking primer button on a 1996 dodge ram 2500 5.9 liter diesel engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel primer button on a 1998 dodge 24 valve Cummings turbo diesel?

The 24 valve has an electric lift pump. It does not have a primer button.


How do you prime a John Deere 5310 diesel engine?

best way is take off fuel filter fill with diesel put it back on the pump the primer button a few times then crank tractor


Your craftsman 6.0 is leaking fuel out the primer button is it repairable what part do you need?

The primer button/assembly will have to be replaced. The part is available at Sears or just about any mower parts/sales stores - even at some auto parts stores (Plus Parts, etc). Be sure you note and remember (or draw a picture) how the fuel lines are routed to/from the primer for correct re-assembly.


How do you get air out of fuel line in Cummings 300 diesel?

I have a 1994 Monaco RV with a Cummings 300 diesel with what I believe has air in the fuel line. How do I remove the air, I pushed the primer button below the fuel pump until I could smell fuel, the engine turned over for about 15 sec. and still no start. Help! Dan


How do you repair leaking fuel primer bulb on Toro lawnmower?

Don't know that a leaking primer bulb can be repaired. Most likely, you have to replace it. You don't want to forget the routing of the fuel lines!! You might want to make a drawing of the routing before you remove the primer bulb.


How do you repair a leaking primer bulb on a craftsmen snowblower?

You don't. They are not difficult to replace.


Starting a diesel engine not started for months?

tyred to primer the system by add gasoline on a rug and putting around the filter and add little bit of gas in the system


How do you get air out of fuel line in Cummings 300?

I have a 1994 Monaco RV with a Cummings 300 diesel with what I believe has air in the fuel line. How do I remove the air, I pushed the primer button below the fuel pump until I could smell fuel, the engine turned over for about 15 sec. and still no start. Help! Dan


How do you bypass a primer button that has a hole in it?

Just find something you can squirt gas into the small hole behind the button.


Why wont your deisle engine start after running out of fuel?

Diesel engines need to be primed when the have ran out of fuel. You should be able to find the primer either ontop of the fuel filter on near the inlet manifold


Can small engine primer bulb be bypassed?

Primer bulbs on small engines take the place of a choke on the carb . If your carb has a choke on it then you could probably bypass it . The object of the primer and the choke is to give the engine a extra charge of gas to help it start when the engine is cold . If you take this away then the engine will be hard starting if it starts at all .


How do you prime a dodge diesel truck?

To prime there is a primer button below the fuel filter about 6 inches, push that a few times. Usually you will need to bleed the lines if it is not starting, use a wrench to loosen two or three of the fuel lines where they connect to the injectors, then crank the engine until fuel comes out of the lines. Tighten the fuel lines again and it should start just fine.