answersLogoWhite
Auto Parts and Repairs
Windshields and Wipers
Sony PSP
Sony PSP Go

How do you fix the blinkers or flashers when they stop working?

343536

Top Answer
User Avatar
Wiki User
2015-07-15 19:24:33
2015-07-15 19:24:33

If just one side stops, look and change the bulb that isn't on. If none work, replace the fuse or flasher.

1

Related Questions

User Avatar

My 89Chevrolet astro van digital speedometer stop working. How do I fix it

User Avatar

For safety reasons, you should fix the problem so that you blinkers work correctly. This is a fairly common problem and the cost to repair will likely be minimal. For inspection purposes, however, your blinkers only need to work correctly during the inspection.

User Avatar

If your turn signal flashers stopped working, play with the emergency flasher button on top of the steering column. Our 97 Sable turn signals quit once and luckily I pushed the emergency flasher button in and out many times and the signals have worked ever since. But the emergency flashers don't work, but I can live with that.

User Avatar

this could be a blown fuse, defective flasher, loose connection, or burned out bulb tk

User Avatar

there are 2 flasher cans in vehicle.one operates hazards and the other operates the blinkers. change the one that operates the blinkers and your blinkers will work

User Avatar

They dont work. The bulbs are the most problems. Fix it!

User Avatar

The update was meant to stop flashcards from working. There's no way to 'fix' it.

User Avatar

Turn the hazards on and check for a burnt-out bulb.

User Avatar

If you check the fuse circuit box, there is a fuse for your blinkers. Just change to the amp that is required which is probably a 20. Should work good as new again

User Avatar

The turn signals and hazzard lights operate by 2 separate "flasher" units. They are usually found up underneath the dash. They are round (about the size of a half dollar) and just pull out. They are pretty cheap. (less than $5)

User Avatar

the ar two flashers behing the dash next to the lighter. you will need a 27 torx and a 7mm nut driver to get to them

User Avatar

the hazard switch has two sets of contacts. when hazards turned on, blinkers cannot work,even if hazards dont work.for blinkers to work, hazard sw must be in off position-this reconnects blinker circuits to work normally. BUT-the contacts in the hazard sw get dirty and wont reconnect the blinkers to work

User Avatar

You need to check your thermostat, pretty cheap fix

User Avatar

First check if your fuse , have gain bad , \if its alright , then check the wiper motor .

User Avatar

The hazard and blinker lights are located behind the dashboard tray. To fix the fuse, you unfortunately had to take the dashboard out.

User Avatar

First you have to check your flasher, this is located where the fuse box is, this could be one of your problems.

User Avatar

take to the dealer or got to a salvage yard and buy replacement parts

User Avatar

Could be the bulbs or the fuses or the flashers or the signal switch assembly


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.